For anyone whos cruise control is on the steering wheel took me a minute to figure out , u can raise the rpm with cruise control by pressing the on off switch for cruise control and the set button and holding for a few seconds may have to do it a couple times to get to 700
Secret tip: if all else fails, you can turn on your engine and then pull your ignition fuse. Just make sure to put that fuse back in and then restart engine before moving the truck at all. 👍
@@philipbond4088 I meant, "where in the fuse box is the ignition fuse located?" Doesn't matter. I eventually located it and the hack doesn't work. Manufacturer's must read these posts and routinely update their software.
For anyone wondering why it does not work in their truck, it is based on how the truck is programmed some have no limit while others have a hard limit that can not be exceeded. It depends on how the company has had the truck programmed.
We have a 2022 Kenworth t680 and the mechanics kept telling us to keep it above 1500! Damn truck was so loud. Thank you for this video. Finally a truck that’s quiet when idol. 🙌🏼
That is ridiculous, those are crappy mechanics. 900should be max 600 minimum. 1500 is higher than running in top gear down the highway. Low idle(500-600) is not good but 1500 is WAAAAYYY too high. If those are company mechanics, you should let the company know that they want you to waste fuel.
So if you hate the truck shaking you in the middle of night as your auto start stop feature is on. Listen here you can set your truck to 60 is my lowest and then make sure that the truck never reaches 60 and it will run all night. You do this by turning the AC in the front on low and then in the back shut a vent if needed until you have a good comfy temp
Any idea on how to override idle in 2021 kenworth without that cruise control switches. The one I’m driving don’t have cruise control switches on the dash. These are on steering wheel and DO NOT set while parked. Longest setting is 30 minutes,but never stays on that long,longest is 6-8 minutes
This does not work if your truck is programmed to idle no more than xxx number of minutes without going into drive/reverse brake released, or fuel pedal depressed. Thats called a hard idle timer. Ive seen a guy who made a brace that presses against the plastic around the pedal and the seat. He had a cam that rotated on a timer and ever 6 min or so it would press in the fuel pedal and override the idle shut down
Been trying this on mine and it doesnt work..only to find out, its a feature on the truck only Kenworth can remove and only after it reaches a certain millage. So cant sleep at night as it keeps shutting off then im waking up swesting buckets😢
Anybody doing this idle method will burn more fuel per hour. If your on level ground just set the trailer brakes and release the the park brake and enjoy your rest on low idle.
I noticed that when my ABS, TC (and some other icon) sensors all appear at once on the dash, I can circumvent the idle shutdown. Those sensors just randomly pop up when I start the engine sometimes, and then go away the next time I start the engine. If someone knows how to trip those sensors intentionally, that would be the hack.
For anyone whos cruise control is on the steering wheel took me a minute to figure out , u can raise the rpm with cruise control by pressing the on off switch for cruise control and the set button and holding for a few seconds may have to do it a couple times to get to 700
For anyone whos cruise control is on the steering wheel took me a minute to figure out , u can raise the rpm with cruise control by pressing the on off switch for cruise control and the set button and holding for a few seconds may have to do it a couple times to get to 700
Your comment has been the most helpful. I have the 2023 and have been trying to figure it out for over a week
Thanks for the insight bro 🔥
Secret tip: if all else fails, you can turn on your engine and then pull your ignition fuse. Just make sure to put that fuse back in and then restart engine before moving the truck at all. 👍
Where's the ignition fuse?
@@FirstnameLastname-wl9jx check the fuse box
@@philipbond4088 I meant, "where in the fuse box is the ignition fuse located?" Doesn't matter. I eventually located it and the hack doesn't work. Manufacturer's must read these posts and routinely update their software.
For anyone wondering why it does not work in their truck, it is based on how the truck is programmed some have no limit while others have a hard limit that can not be exceeded. It depends on how the company has had the truck programmed.
We have a 2022 Kenworth t680 and the mechanics kept telling us to keep it above 1500! Damn truck was so loud. Thank you for this video. Finally a truck that’s quiet when idol. 🙌🏼
That is ridiculous, those are crappy mechanics. 900should be max 600 minimum. 1500 is higher than running in top gear down the highway. Low idle(500-600) is not good but 1500 is WAAAAYYY too high. If those are company mechanics, you should let the company know that they want you to waste fuel.
Did it work because 800 didn’t work for me?
Thank you so much! Its such an annoying feature. Worked on my 2021 T880
If you have a trailer attached you can pull your trailer brakes and push in your parking brakes it'll work that way also
No it doesn't
It doesn't work on KW
Still works on a 2023 T680! Thanks!
That's cool cause my APU unit not working
So if you hate the truck shaking you in the middle of night as your auto start stop feature is on. Listen here you can set your truck to 60 is my lowest and then make sure that the truck never reaches 60 and it will run all night. You do this by turning the AC in the front on low and then in the back shut a vent if needed until you have a good comfy temp
depending on who you drive for that does not work. some company truck will not idle unless you push down on the gas pedal every few minutes
They can shut that off too.
thsts the way mine is too
@@Bendigo1
They can then teach their CFO who purchased them to drive, or get a hotel room every night for me.
Thx bro... life saver
THANK YOU !!!!
Thanks.!!.. is work on mine...
Nice info ❤
they dont have optimized idle?
from my experience with a cummins motor you shouldn’t ever idle at low rpm always at least 1000rpm ❤
It works on 2024 T680. THANK YOU!
Good to know! You're welcome.
Any idea on how to override idle in 2021 kenworth without that cruise control switches.
The one I’m driving don’t have cruise control switches on the dash.
These are on steering wheel and DO NOT set while parked.
Longest setting is 30 minutes,but never stays on that long,longest is 6-8 minutes
I have the same truck and nothing works so far
Can ya leave your trailer brake in and just pull your tractor
It doesn't work on KW
Works for the cascadia too
This does not work if your truck is programmed to idle no more than xxx number of minutes without going into drive/reverse brake released, or fuel pedal depressed. Thats called a hard idle timer.
Ive seen a guy who made a brace that presses against the plastic around the pedal and the seat. He had a cam that rotated on a timer and ever 6 min or so it would press in the fuel pedal and override the idle shut down
Jesus. Should’ve just returned the truck get a refund. Piece of garbage truck.
Pull your trailer brakes and push in parking brakes with truck in neutral
Been trying this on mine and it doesnt work..only to find out, its a feature on the truck only Kenworth can remove and only after it reaches a certain millage. So cant sleep at night as it keeps shutting off then im waking up swesting buckets😢
2018 testing it now.
I just did it mine 56'F still running
It's 35 for the low temperature
Thank you!
it doesnt have optimized idle?
Shuts off after 5 mins if it's not more than 76° outside...
Anyone know how to do this for a 2018 peterbilt 579?
If you own it just save the hassle and go to a mom n pop shop and have them hook up the laptop and turn the feature off.
Anybody doing this idle method will burn more fuel per hour. If your on level ground just set the trailer brakes and release the the park brake and enjoy your rest on low idle.
They've got a block for that, too. Lasts longer than five minutes, but definitely does an idle shutdown after 10-15, still.
My 2019 didn’t work. 5 min no matter what and it shuts down. Unless you are going more than 3mph.
Honestly don't know about the 2019's. You might have to do something a little different, or it may not work at all on that year rig, idk...
In the same boat. I switch it to 30min to at least give me that much but still goes off.
I noticed that when my ABS, TC (and some other icon) sensors all appear at once on the dash, I can circumvent the idle shutdown. Those sensors just randomly pop up when I start the engine sometimes, and then go away the next time I start the engine. If someone knows how to trip those sensors intentionally, that would be the hack.
Unfortunately, this doesn’t work in mine
It’s not working for me
It didn't work on my 2019 T680
Mine is set at 91° I hate this asd stuff
You should call your company and tell them you need to go to a terminal to get that setting changed, and that it won't idle below 91°.
How much meth did you mix with nicotine?
What the hell are you talking about?
@@michaelmorphew2369 🤣
You don’t do anything 😅😅😅😅😅😅
For anyone whos cruise control is on the steering wheel took me a minute to figure out , u can raise the rpm with cruise control by pressing the on off switch for cruise control and the set button and holding for a few seconds may have to do it a couple times to get to 700