I replaced the Hi/Low & Fog lights on my 2019 Ram 2500 Hemi, it was not easy especially the fog light led install. Connecting the connectors was a handful. Wish you would have shown to reconnect the led fog light connector and the fight with the red sliding clip that doesn't want to slide up, even though the new LED bulb connector is the same size as the Halogen bulb connector. It is not bing botta bum, it is hair pulling out till you learn the trick. Good video to show the difference between the factory halogen lights vs. led lights. I just wish you would have shown the complete install, including all the headaches so I could have avoiding them.
Same here it was a bitch getting that red clip back in the driver side fog light. Passenger side was no problem but spent about 45 min and a lot of cursing but it finally clipped in.
Can you tell me what bulbs i need for a 2021 ram 1500 i select these and it says do not fit when on Amazon but when i search the bulb i need it keeps coming up with these bulbs
Hey- thanks for the informative video, I was wondering how the bulbs are holding up? It’s been a little over two years that you installed them. Thank you
Wish I'd watched this before I started them myself! It took me a little bit to figure out to take out that panel rather than work around the wires lol.
@@shoobiedoubie6871 I just got a 2022 with the etorque so there are EVEN MORE cables on the drivers side, but I did the passenger side in no time after I watched this! Did you have a hard time getting the high beams in?
Nice video have you experienced any problems while shifting from park to drive or reverse? Like either fog light or high bean turn on for couple of seconds? Also how do you like those tires are those falken wildpeak?
@@shoobiedoubie6871 cool. I got mine in yesterday. Love them. I’m not picky about the positioning of them. Worked too hard to get them in! What did you do with that driver piece that is connected to lights? I tucked mine on the light housing and screws the dust cover back on. You think that is ok?
@@513cats that’s what I did except I used the double backed foam tape. Did your truck flash a few times after you installed them? Mine flashed highs and lows on and off a few times then hasn’t happend since, just curious if you used can bus error eliminator or resistors?
I started this channel because I strongly dislike watching people’s videos that don’t explain jack correctly or record like if it’s a middle school fight lol.
I have a Ram bighorn 2019 and I’m having trouble installing my GTR 2 led low beam bulbs I’m going thru wheel well but have trouble peeling back mud guard it’s nearly impossible going Thu engine area high beams you can do.
I bought the same set up for my 2020 Ram1500 BigHorn. Everything went together no issue. 5 minutes later 1 started flashing and went out then the others all followed suit. Looked like a squad car and then nothing. Took them all back out out in the stock bulbs no issues. No clue why they did this .. ????
Did you have any issue getting ready the red tab back on the fog lights? I bought some las fit that I returned because of that tab wouldn’t go up with them. Awesome vid btw.
There was a 5 month update at the end of that same video. It’s still going bro 💪🏽. I did the repair back in March of 2020 so it was definitely worth it !
I recently put L.E.D low beams on my '22 ram with the stock halogen headlights and I like them but I've got people driving flash their Highbeams because my lights are too bright, do you think I need to adjust them down?
I’m pretty sure it will, the best way to know is to check the bulbs that are already installed. They should be labeled, and just buy the same bulb type, but LED.
@@Jnu925 not really bro, I was having issues with my my 2015 ram when o bought these so I had to buy anti flicker harnesses, but I didn’t have any issues with the 2019.
Very well presented and concise. Keep making more videos man this one was helpful in pulling the trigger on the upgrade for sure
😎🤙
I wish they would make this more accessible when it comes to replacing bulbs..
Are you still using these to this day? If so, have they held up? Great video btw
I replaced the Hi/Low & Fog lights on my 2019 Ram 2500 Hemi, it was not easy especially the fog light led install. Connecting the connectors was a handful. Wish you would have shown to reconnect the led fog light connector and the fight with the red sliding clip that doesn't want to slide up, even though the new LED bulb connector is the same size as the Halogen bulb connector. It is not bing botta bum, it is hair pulling out till you learn the trick.
Good video to show the difference between the factory halogen lights vs. led lights. I just wish you would have shown the complete install, including all the headaches so I could have avoiding them.
Same here it was a bitch getting that red clip back in the driver side fog light. Passenger side was no problem but spent about 45 min and a lot of cursing but it finally clipped in.
You made it look easy. I nearly took the truck back to the dealer
Can you tell me what bulbs i need for a 2021 ram 1500 i select these and it says do not fit when on Amazon but when i search the bulb i need it keeps coming up with these bulbs
Hey- thanks for the informative video, I was wondering how the bulbs are holding up? It’s been a little over two years that you installed them. Thank you
Did you have to adjust the angle of the low beams as well?
Since this video is a year old, have you had any problems with your lights flickering in the past year? I’m hoping I won’t need a canbus decoder.
One of the fog lights just burnt out a month ago, I emailed them, and they sent me a new set 🤙. Besides that, no canbus issues.
@@shoobiedoubie6871 awesome!! Thanks for the quick reply. Mine will be delivered Tuesday. Great video
You’re video came through again for me! Thanks brother.
😎🤙
Great video brother. Ordered mine today. Thanks for the great walkthrough
Wish I'd watched this before I started them myself! It took me a little bit to figure out to take out that panel rather than work around the wires lol.
Yeah bro, there’s no way I was going to be able to do it from the top 😂
@@shoobiedoubie6871 I just got a 2022 with the etorque so there are EVEN MORE cables on the drivers side, but I did the passenger side in no time after I watched this!
Did you have a hard time getting the high beams in?
@@lbf5984 Congrats on the new truck ! 😎 No bro, the high beams were a bit easier than the low beams
Nice video have you experienced any problems while shifting from park to drive or reverse? Like either fog light or high bean turn on for couple of seconds? Also how do you like those tires are those falken wildpeak?
No problems while shifting or driving.
And the tires are great. No complaints. I live in Los Angeles so I don’t off-road too much.
Did you put the ballast inside of the housing to put the cover on?
Amazing video the before and after was helpful
Thanks for this video man! Very informative!
Thanks for posting this. Just bought the same bulbs for my 2019 Ram as well. Looks good bro.
Thanks bro ! Good luck ! 👍🏽
Just posted a video on how to adjust the lights too bro ! Just in case the headlights up being lob sided and uneven 🤙
@@shoobiedoubie6871 cool. I got mine in yesterday. Love them. I’m not picky about the positioning of them. Worked too hard to get them in! What did you do with that driver piece that is connected to lights? I tucked mine on the light housing and screws the dust cover back on. You think that is ok?
@@513cats yeah I also tucked it into the housing lol
@@513cats that’s what I did except I used the double backed foam tape. Did your truck flash a few times after you installed them? Mine flashed highs and lows on and off a few times then hasn’t happend since, just curious if you used can bus error eliminator or resistors?
You had the best video especially showing to the LED needs to be vertical great video bro .
Thanks Phillip, I always try to do my best in the videos 🤙🏽
I started this channel because I strongly dislike watching people’s videos that don’t explain jack correctly or record like if it’s a middle school fight lol.
I have a Ram bighorn 2019 and I’m having trouble installing my GTR 2 led low beam bulbs I’m going thru wheel well but have trouble peeling back mud guard it’s nearly impossible going Thu engine area high beams you can do.
How to keep fog lights on when high beams are on because they turn off when highs are on?
Pull the lever towards you and hold it, both brights and fogs will turn on. But you gotta hold it.
@@MetalMiIIs thanks but no thanks. Unwilling to hold that while driving on dark country roads
So where did you store the ballast inside the dust cap?
Damn that truck naaaiiiice
I bought the same set up for my 2020 Ram1500 BigHorn. Everything went together no issue. 5 minutes later 1 started flashing and went out then the others all followed suit. Looked like a squad car and then nothing. Took them all back out out in the stock bulbs no issues. No clue why they did this .. ????
Hey the link to the lights you posted doesn’t send me to the product page. Could you update the link please?
Sorry about that, I just updated it ! 🤙🏽
@@shoobiedoubie6871 thanks so much!
Did you have to adjust high or low on beam height?
What lift do you have on your truck brother 🤔 really like the stance
Does your 6500k match the LEDs lights under the door mirrors?
No sir, the lights under the mirror are a tad bit “whiter”
Hey man. I tried clicking on the link for the high and low beam bulbs but the link doesn't work.
Did you have any issue getting ready the red tab back on the fog lights? I bought some las fit that I returned because of that tab wouldn’t go up with them. Awesome vid btw.
hey question, how is the jb weld on the oil pan holding up? and how long did it last? didn’t see the update vid
There was a 5 month update at the end of that same video. It’s still going bro 💪🏽. I did the repair back in March of 2020 so it was definitely worth it !
Great video!
I recently put L.E.D low beams on my '22 ram with the stock halogen headlights and I like them but I've got people driving flash their Highbeams because my lights are too bright, do you think I need to adjust them down?
Broooo ! I get flashed all the time too lol. It’s up to you, I posted a video that shows how to adjust the headlights.
@@shoobiedoubie6871 I’m gonna give that a try today, nice set up by the way
@@stosgarage456 thanks bro 🤙
Are straight white or do they have a blueish tint to them? How they holding up too? Was planning on 6000k leds but these are 6500k
They have a slight bluish tint. But I like it, it’s not exaggeratedly blue.
It’s a crispy white lol they’re still going bro 🤙🏽
Did you get a light on on your odometer?
Good install but bad idea to touch all over the lighting part of the LED with your bare hands. They'll last about a month before it goes out on you.
Appreciate the video! 👍🏾
Are the fog lights 6500k bulbs too or are they yellow 3-4k?
Yes they are 6500k 🤙
@@shoobiedoubie6871 Ok, Thank you!
Will this work on a 19’ classic?
I’m pretty sure it will, the best way to know is to check the bulbs that are already installed. They should be labeled, and just buy the same bulb type, but LED.
What size wheels do you have on there? Is it lifted or leveled? Good looking truck bro!
It’s leveld bro, it’s got LT275/70R18 tires on it rn 18” rims. I am going to get 33s soon.
Mah boiiii💯🔥
Does all the extra wiring that comes with the Led bulbs fit inside the dust covers and if not what do you do to fix that ?
Did you ever figure this out?
Still performing well?
Oh yes sir ! I can everything at night and I have 35% tint on my windshield and 5% all around lol
Should fit a 2021 Ram?🤔 According to Amazon it won't. I got a 21 Bighorn with stock HID 🤮
No bro, this will only fit halogen bulbs (regular bulbs) not HIDs sorry bro
@@shoobiedoubie6871 Well dang I made a mistake, my 21 Ram does have Halogen bulbs...
@@Jnu925 Dope! Then I highly recommend you get these bro, they’re bright as hell 🤙🏽
By the way is it required to have that anti flicker harness?
@@Jnu925 not really bro, I was having issues with my my 2015 ram when o bought these so I had to buy anti flicker harnesses, but I didn’t have any issues with the 2019.
Does anyone recommend using the decoders on a 2022 Ram with halogen lights?
Only if you are having issues with your lights, if not, you should be fine.
That’s great vedio dude i will try this same thing like you i just order by Amazon 🤟🤙🤙
Where did you put the driver?
What driver?
@@shoobiedoubie6871 it’s the rectangle part that’s connected to the light
@@MarkBunoy I just shoved into the housing making sure it won’t disturb any wires or anything 🤙
@@shoobiedoubie6871 thanks bro
You 100 percent need decoders
canbus error code?
None so far
Man bro I bought those for my 2020 ram and only one light worked and they don’t even get back at me to replace them
Damn, that sucks bro. Mine still work great and this truck is my daily.
@@shoobiedoubie6871 yours came with decoders idk why mine didn’t and I ordered the same one as u cause I watched ur video 😂
We don’t put LED bulbs in a reflector style headlight you’re gonna blind oncoming traffic