Відео

Thanks Ledgend 🎉

Surprise! There’s a 3rd adjuster. Also, on the FZ/MTs, there’s one out of the three adjusters that’s painted white which is synced to the ECU, which should NOT be adjusted, but rather used as the setting for your other two adjusters.

Getting ready to do a cat back on my rc390! With a Cat back no tune is necessary correct? Not a full just removing pre muffler and Acropovic shorty.

Great guide man. Sometimes it's easier to just watch a video compared to reading the service manual, especially when the manual calls for a specific vacuum synchronizer

I’m new to the motorcycle world so I might be wrong but i don’t see the purpose of tuning after installing an aftermarket exhaust. I see that the MT-07 has an 02 sensor. The ECM gets the input from the 02 sensor and makes fuel adjustments depending on the reading. Well at least that’s how it works on fuel injected cars.

Hey Brad, I got an MT07 second hand that has the carbon akra exhaust but the DB killer has been removed. Can't for the life of me figure out how to get it back installed. If I work backwards to get the muffler off, do I need to loosen the header bolts? Or can I just take off the muffler bolt and be good?

Great video!

I contacted Akrapovic and he told me that with this exhaust there is no need to do the control unit

Where can I get the windscreen

there was a piece missing between the 2 seats. i was having trouble bolting mine back so i put some zip tides. the bike was running rough. i though it needed a tune up but it has mouse food in the air filter.

Did you say what plugs the are?

Great video had plastics off in 10 mins new keyless gas cap fitted and 5mins to put plastics back on cheers mate

Bro you’re a legend for this video.

I love your videos B-Raaaad!! I to have a 21 MT-07 so this really helps. Thank you and keep up the good work

Do you need to unplug negative on battery when you splice ?

Very Lean or too much timing advance..

Thanks a lot for the detailed video. I did get the coils out with a small rope loop around their connector pulling from the top with one hand and the other doing small rotations from the side.

What is the blue rag called. I don't know hot to call in Thai.

"It's INSANE!!!" I'll put this in my watch later list but I can already tell the title is a hyperbole

I used this video as white noise to go to sleep

Can you show how to install the tune itself?

How often should I change the oil? If I ride about 500-700 miles a week so to say?

The bikes computer will self adjust, no need for a tune, those plugs looked just fine.

Please send us an email.

So with that exhaust do you have to tune it

"What's goin on everybody" ...literally every American on UA-cam

When you are uploading the new map, does the bike have to be turned off?

$1700?! WTF? For that kind of money I think there are better choices out there for sure. I'd try just removing the baffle first. That's just stupid money for an after market system.

When you are uploading the new map, does the bike have to be turned off?

Just finishing fitting mine following this video, very helpful. Just unplugging that damn exhaust cable was a pain

now how do take ur tyre off with those on ur bike

Do you need to tune it after you get the full exhaust?

Reinstall steps saved me, thanks so much

haha , i told you , right again

Thanks for posting this, I'm making a custom backrest for the bike and realized I needed to get the light out. I'm actually mounting it on the two main bolt holes that hold in the light onto the frame. This video gave me everything I needed to know! =)

Great video, thanks for sharing!

U should remove the db killer

Is it better to do 15 ft/lbs or 32 ft/lb ?

Hey B-Rad, do know if the process is pretty much for the same for a 2024 mt 07 ?

I did both 🤦🏻‍♂️. First I went pc 5 and the ots tune was ok. But everyone in the mt07 community will roast you to death telling you a flash is way way better ect. So I got talked into sending mine to 2wdw. So now I have a pc5 sitting around for no reason….

I noticed on my stock r7 that there are tons of pops and crackles on decels. Of course it is incredibly muffled and very subtle, but you can definitely hear it, especially after downshifting. The bike runs lean from factory.

Appreciate the help

My workshop changed my spark plugs at 10k last year.. feeled like scam bc yamaha manual says just at 20k. I have a MT07 2021. But it was propaply due who knows haha. Next time I will do it by myself.

Do not torque it to 32ft pound, the manual has a mistake in it, tons of people have stripped the threads using that torque value and had to replace the oil pan. 17-20ft pound is plenty of force.

Nice one Brad, appreciated.

42N.m sounds a lot.....

Sadly not allowed in Germany (Europe)

Do you actually feel a power difference after doing this?

Do you change crush washer with every change or every other?

Dang, that's WITH the DB killer?? I don't even want to know how it sounds without it. Btw, that 2021 color scheme is the absolute best.