Відео

Due to the belt touching the left /outter side of the front sprocket, my belt started to show some signs of peeling. Did you manage to centre the belt in the front sprocket too?

Do you still enjoy it after 2 years? Has it been reliable

Hello, I changed the rollers and the belt on my AK550.Put everything back I mean untill the variator nut started the engine and the variator nut and variator comes out, even the belt.Put everything back and the scooter doesn’t start, or if in the final starts it sounds a metalic sound from the transmission place.Do you think I didn’t put the belt in place correctly?I didn’t pressed the clutch back with those 2 bolts when I put the belt back in. Could you please give me an advice what should I do to make it work again?Please.

NO...the C 19.2mm too tight , 20mm~21mm is good /按照 kymco維修手冊去調整的皮帶緊度，約在15000公里後，皮帶會開始發生異音

Did you experiencing problem of noise drive belt cos its rubbing outside wall of front pulley?

Awesome video! You made this super easy 🤟 And yea my factory belt it hugging the left of the sprocket

Does the belt adjuster need to be loosened to adjust the belt alignment?

UPDATE: How to properly tighten/align the belt. ua-cam.com/video/Hsjlz5qMkd4/v-deo.htmlsi=F2D5jnKojNo3u9ir

Great video. Thank you

Thank you so much for all your videos

I would think that you should invest in a dial caliper to measure and record the dimensions of the axle tension blocks. I think that if you had measurements accurate to the thousandth of an inch and then repeat those measurements when you reassemble the rear wheel. That black mark could leave you anywhere in that marker space.

Solid, to the point video! Thank you for making this and showing the steps

You don't need this special key.... just hit it wit power toll impact

Can you lane split on the AK 550?

I have the 2022 Kymco AK 550i ABS, what is your specs on your REAR Brake Pads, and your Rotor?

Where you buy that speacial tools?😊

I just bought that exact bike. I’m finding the throttle to be extremely twitchy! Even in rain mode it’s like an on/off switch! Is your bike that way? Or even more so, was it that way new and finally got broken in after time? I kid you not, my 2022 AK550 is crazy to ride. I let off the throttle and I don’t even have to pull the brakes. It’ll almost come to a full stop with out me braking. Is your bike these two ways? If not, I need to know so I can head back to the dealer. Any help would be greatly appreciated! Twitchy throttle and a major loss of speed when letting go of the throttle. 🤙

Thank you

Used these Shad cases myself....I got the small cases so I didn't overpack on long trips 🙂

Simple, quick look, not more to be said, a picture is worth a thousand words! You did the trick!👍🏻

Is it necessary to change coil at same time as plug?

Well done Thank you.

تكنولوجيا التقدم من هوندا عالميه ❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤❤

Great video, thank you!

nice video can you give us the link of the website where you got the kymco parts?

I purchased a kymco CV3 which is basically the ak550 great video. Will help me later in time 😀

I don't know why Kymco is not selling the ak550 premium in the US... That bike came out in 2022 and it has so many updates and goodies...

Does it fall apart at 10k miles like Chinese made Wolf scooters?

Fkn gorgeous man. I hope you still have this. It's freakN perfect. Love the way its sounds and everything. Great job. I'd love to get one of my own. 🥰👍

How often do you need to replace the roller weights ? I can't find it in the manuel

Nice informative video.

Very good description of the install. My dealer installed the official Battery Tender pigtail on my AK 550. Those usually have 18 ga wire and are good for up to 7.5-10 amps. But I wanted to use mine for also running my Slime mini compressor which requires 15 amps minimum. It is NEVER a good idea to simply replace the fuse with a bigger fuse unless the wire is big enough to handle more current. I replaced the official BT pigtail with one that has 16 ga wire which is good for up to 20 amps max. It is also a few inches longer than the official pigtail. I can now pump up my tires on the road. I also bought a battery clips to SAE cable and a 3 ft SAE to SAE extension cable with a removable gender changer adapter to be able to assist other mc riders while traveling. The battery clips to SAE cable is for those who don't have a BT pigtail installed. All of these are very small so I carry them any time I travel cross country.

I thought you were going to drop it ,when you were leaning side to side.

Its service time. Yes great video. More videos please.

Hi Handsome. Great looking moto. Could you talk about ,when and why you chose this brand,be specific? How do you like the suspension? What should you upgrade or add to the new 2025 model? Where do you have plans on traveling with your new motorcycle? National Parks or landmarks? Please add safety lights and high visibility stickers on the back ,3m for night driving. Be safe God bless you.

What did you use to get the spring off the rear shock?

Could you kindly put the part number for the rack? I could not find the side tacks separately.

Hi do you happen to know what size tool do i need to remove front tire? Im buying a brand new ak in the philippines for our philippine loop. I want to buy all the tools i need here in the u.s before my flight.

It's nice. Mine looks better but it isnt

That is a really sweet setup! Also a fellow South Carolinian here. I'm looking to upgrade from my Honda ADV 150 soon. Not a lot to choose from around here when it comes to bigger scooters, but I was thinking either the Yamaha Xmax 300 or the AK 550. Seeing this setup definitely sways me a bit more towards the AK 550 though.

I live in Paris. The AK550 is the most stolen maxiscooter after the TMax. Also a lot of the AKs get their Brembos stolen to retrofit other bikes with bespoke brackets. People here have a joke that if ur Brembos get stolen, go check out those who ride a Tmax that have aftermarket brembos on them )

Thanks a lot, buddy! Have a great Thanksgiving!

That looks so cool

Change the belt at 12k? I'll stick with my old Vespa, which is practically maintenance-free

I have a ak550i, is it difficult to change the drive belt? Can you show that also please? 💪

I have a kymco ak 550i super touring. My drive belt got broken. Want to replace it my own. Is this a difficult job to do?

Most important question of them all, How do you reset/turn off service light after oil change?

the extension for spark plus I get it a 5/8" Swivel Magnetic Spark Plug Socket, 3/8" Drive x 10 in. Total Length do I need more length ?? or 5/8" Magnetic Swivel Spark Plug Socket, 3/8" Drive x 11" Extension, 12 Point, CR-V Steel, 360 Degree Swivel

thanks for the tip, I get it all the tools belt , filter, roler it have 9000 mi.

hey dude, how is the under seat storage on this thing? And also how does it handle freeway speeds. I have a 2023 xmax 300 and it sucks on the freeways. Its super skiddish and the wind protection is awful and so is the suspension