ZD550 Drone Build - Installing The Parts
Вставка
- Опубліковано 17 жов 2024
- The third in the ZD550 drone build series. In this one we take the harvested parts and install them into the ZD550 frame we just finished.
Website - bentsprockette...
00:05 Introduction
04:33 Threadlocker Works
04:50 Masking Tape Arrows
08:13 An Amazing Ratcheting Tools
10:27 The Motors
15:00 The Motor Mounts
16:45 A Copilot
18:50 Let's Get This Motor On There
23:09 Laying Out The ESCs
24:56 Making The Battery Mount Shorter
28:08 Securing The PDB
30:45 I Call Ma At This Time Every Other Day
35:10 Looking At The ESCs
40:01 Plugging In The Motor Wires
42:10 Cleaning Up The Wiring
42:53 Securing Other Components
44:43 Signal Distribution Board
47:42 Self Healing Silicone Tape
50:21 Hooking Up The Copilot
53:22 Mounting The Flight Controller
54:08 3D Printed FC Carrier Plate
57:24 Do Not Block FC Ports
1:02:35 Checking The voltages
1:03:32 Overview
1:12:44 Conclusion
#drone #drones #dronebuild #diydrone #zd550 - Навчання та стиль
🔥🔥🔥
Abi seviliyorsun Türkiyeden selamlar
I appreciate it, thank you.
hi can i use 340kv motors instead and a servo to carry 3 kg payload with this?
You should be able to. The link below shows a motor that is a 340kv having a capacity of 1.5kg with 7" 6.2 pitch props. The current config of the quad puts us around 2.25kg. That should give you enough headroom. Are you trying to get more stability and stamina out of the drone? If so, that is a direction to go. If you want snappier movements you would need to increase your kv, but that also decreases your payload cap. On the servo, if you are planning to drop your payload, be careful as that can get you into some possible trouble with the authorities depending on where you are. There are extra channels in this setup so you can attach more actuators and servos as with the gymbal and use the mix on your radio or QGC to route the channels.
Hope that helps. :)
Yu de na di tɔp pan di tin dɛn we yu ebul fɔ du. A de gɛda am afta a dɔn wach yu asɛmbli fim. Wea a kin fain di fc fixed guard??
Thank you. The link to the Pixhawk 4 adapter/carrier can be found here. bentsprockettech.com/diy_projects/zd550-drone/
thank you