FIX Oil Valve Cover Gaskets BEFORE It's TOO LATE!

Replacing Oil Valve Cover Gaskets: Step-by-Step Guide
Gather Necessary Tools and Materials:
New valve cover gaskets
Socket set
Torque wrench
Gasket scraper or razor blade
Clean rags
Engine oil (for lubricating gaskets)
Preparation:
Ensure the engine is cool.
Disconnect the negative battery cable.
Remove any components obstructing access to the valve cover (air intake, hoses, etc.).
Remove the Valve Cover:
Unscrew the bolts holding the valve cover in place using the appropriate socket size.
Carefully lift off the valve cover, being cautious not to damage any surrounding components.
Clean the Surfaces:
Use a gasket scraper or razor blade to remove old gasket material from the valve cover and engine surface.
Clean the surfaces with a rag to ensure a good seal for the new gasket.
Install New Gasket:
Place the new valve cover gasket onto the valve cover. Ensure it fits snugly.
Apply a thin layer of engine oil on the gasket's contact surface to help with sealing.
Reattach the Valve Cover:
Position the valve cover back onto the engine.
Hand-tighten the bolts in a crisscross pattern to ensure even pressure.
Use a torque wrench to tighten the bolts to the manufacturer’s specifications.
Reassemble Components:
Reinstall any components that were removed to access the valve cover.
Reconnect the negative battery cable.
Check for Leaks:
Start the engine and allow it to run for a few minutes.
Inspect the area around the valve cover for any signs of oil leaks.
Dispose of Old Gaskets:
Properly dispose of the old gaskets and any materials used during the replacement process.