Will the glass beads stuck under the fins. Sir, How much time media can be hold in vapor honing cabiney and which corrosion inhibitor is the best for aluminum and cast iron engine components.
A good flush with water after blasting gets all the beads out from the fins. Not sure of the best rust inhibitor to be honest. I know there's a few on the market. 3/4 of a bag is enough media
I think the air pressure was around 60 psi. The water pressure is a lot higher, can't fully remember what the water pressure is on that machine but they're normally about 1500-1800 psi
😯 Amazing!
Yeah it turned out better than I thought thanks
Will the glass beads stuck under the fins. Sir, How much time media can be hold in vapor honing cabiney and which corrosion inhibitor is the best for aluminum and cast iron engine components.
A good flush with water after blasting gets all the beads out from the fins. Not sure of the best rust inhibitor to be honest. I know there's a few on the market. 3/4 of a bag is enough media
At what pressure did you blast it?
I think the air pressure was around 60 psi. The water pressure is a lot higher, can't fully remember what the water pressure is on that machine but they're normally about 1500-1800 psi