A little commentary of what is going on would be helpful. There is no explanation of why or what you are doing to go with the video. I guess if you are a mechanic already, this would not be helpful. Do not understand why there is not a voice explaining what you are doing and why.
This is NOT a very good video. No explanation at all. Its only a good video if you already know what you are doing. Beezness needs to do a voice over explaining what the heck he is doing.
no he's telling you to send your supercharger to him so he can fix it because you will just f*** it up . they're all specialty tools just for that supercharger and nothing else . one job I do not want to do
thank you so much for not having loud annoying music!
I liked the video, it's self-explanatory!
Great video
Thanks great video.....
Perfeito!! 👏👏
I've never seen those brand hand tools before.. What are they?
A little commentary of what is going on would be helpful. There is no explanation of why or what you are doing to go with the video. I guess if you are a mechanic already, this would not be helpful. Do not understand why there is not a voice explaining what you are doing and why.
Cuantos nm se apreta el tornillo ?
👏🏽👏🏽👏🏽
bel video ma dovresti controllare con chiave dinamometrica la taratura della frizione dell'alberino
so the supercharger flywheel should have no play whatsoever back and forth?
Correct
how do you check the slippage of the clutch?
You don't need to...... Ha
Exelente video 👏
Lukely is not my supercharger, bearing wrongly installed and torque wrench is usless on that way... i hope it didn’t fail after few hours..
This is NOT a very good video. No explanation at all. Its only a good video if you already know what you are doing. Beezness needs to do a voice over explaining what the heck he is doing.
Do you realise that you have the bearing around on the wrong way on the shaft ?
And someone should tell him that when your torque wrench clicks that's when you stop! Unless it says Walmart on it.
He made a few mistakes not just bearing
I agree he did make a few mistakes. One of which is you don't apply gasket silicon loop around the bolt hole, if you expect it to seal tight.
Lots of mistakes made
Wathcn 10 min and realized this guy is a hack, Watchh the 3Ft Deep video instead, its done correctly there!
no he's telling you to send your supercharger to him so he can fix it because you will just f*** it up . they're all specialty tools just for that supercharger and nothing else . one job I do not want to do
You can order them through the dealer, hardly special tools....
Repleat with mistakes and hacks
camera angle is awful
Horrible video but IF you are mechanically inclined it’s enough to get an idea