@mrchuckbiker5842 thanks so much for coming in and taking a peek! I think the suggestions on getting a mic was well over due! Thanks again for watching!
@neilwainwright1455 im a pretty small one man garage.. i don't see a laser cleaner in my future.. I haven't decided what route I'll be doing with the cab.. the chassis will be stripped down and coated.. once everything is mocked up.😊
@@MichaelHigh-v9s i still have to pull the engine... give it another good scrubbing to paint it up.. and replaced everything that's leaking.. I may just give that a whirl.. thanks!
@neilwainwright1455 I'm swapping out the intake.. resealing the covers, oil pan, and the likes.. I wont be blowing apart the entire engine... ill be doing a compression test once I get the tester in. As far as the 700r4, I'm gonna change the fluid and run it and see how that goes.. the fluid is extremely clean..... if down the road it needs rebuilt. I'll address it then.. thanks for the comment.😊
Wow I can hear you ,mike is great , appreciate ya , always enjoy your channel
@mrchuckbiker5842 thanks so much for coming in and taking a peek! I think the suggestions on getting a mic was well over due! Thanks again for watching!
Good progress . 👍
@@VinoRatRodbuilds thanks!
Thanks for getting the mic! BIG difference. Every single piece of rubber GM ever used, on the body or the power train, leak.
@kodak_jack the mic is better for sure!
Easy Off works just as good
You could do with a lazer. But anyway you could clean everything ready for paint. Chassis ets
@neilwainwright1455 im a pretty small one man garage.. i don't see a laser cleaner in my future.. I haven't decided what route I'll be doing with the cab.. the chassis will be stripped down and coated.. once everything is mocked up.😊
You should try easyoff oven cleaner sometimes,
@@MichaelHigh-v9s i still have to pull the engine... give it another good scrubbing to paint it up.. and replaced everything that's leaking.. I may just give that a whirl.. thanks!
That engine needs complete strip down and redo of all seals clutch and bearings
@neilwainwright1455 I'm swapping out the intake.. resealing the covers, oil pan, and the likes.. I wont be blowing apart the entire engine... ill be doing a compression test once I get the tester in. As far as the 700r4, I'm gonna change the fluid and run it and see how that goes.. the fluid is extremely clean..... if down the road it needs rebuilt. I'll address it then.. thanks for the comment.😊