Great install video. How are they holding up? I’m thinking about getting a set. Have you done any pivots on them or come down on them hard? Any additional advices?
@@tallica8402 I haven’t had the chance to really do any wheeling or missing since putting these on so it’s hard to say. I would imagine they’d do pretty well though.
Considering these for my on order JLUR. I have two questions: 1. the slider arms seem very close to the pinch weld and may not allow enough body movement without contact. Can you verify the clearance there? and 2. the rear two mounts make good sense to me but the front mount appears to use the actual front body mount bolt to hold the slider. Doesn't that completely constrain the body mount movement? I'm new to the Jeep world so I'm not sure what's acceptable for these rigs. Thanks!
Nice hat! Next time you are at the shop I'll show you some bits that will change your life!
Great video! I was I found this video when I was drill my sliders 😂
Great video! Ordering the same sliders for my JKU this week.
Great video. Debating between these and the LOD Destroyers. Tough choice. Appreciate your video and install tips. The Rusty's look SWEET!!!
3:22 Ha, I have the same rubbed off paint from my Rock Krawler arms.
Great install video. How are they holding up? I’m thinking about getting a set. Have you done any pivots on them or come down on them hard? Any additional advices?
Aswome job 👊, I like 👍
Great video man! I’m looking to get these.
Thanks! I’m loving them so far. Haven’t had the opportunity to bang them on any rocks yet but I’m sure they’ll handle the abuse.
How do these handle rocks being flung from your tires? Do they stop most of it?
One more question. Would they stick out past the fender if the fender was trimmed? Just the two parts of the fender separated I mean.
@@tallica8402 I haven’t had the chance to really do any wheeling or missing since putting these on so it’s hard to say. I would imagine they’d do pretty well though.
@@tallica8402 maybe a hair? They taper in at the fenders for the most part
Sliders look good, now let's go abuse them!
Considering these for my on order JLUR. I have two questions: 1. the slider arms seem very close to the pinch weld and may not allow enough body movement without contact. Can you verify the clearance there? and 2. the rear two mounts make good sense to me but the front mount appears to use the actual front body mount bolt to hold the slider. Doesn't that completely constrain the body mount movement? I'm new to the Jeep world so I'm not sure what's acceptable for these rigs. Thanks!
How have they held up? Have you beat them up?
Haven’t been offroad in a while unfortunately. I have no doubt they’ll take some serious abuse however.
Do u know what they weight ? I know they are heavy.
Looks great but extremely overpriced for that price you could get amp steps