we a nissan np300 2.5. the vehicle has no power but if you switch off and on whilst the vehicle is in motion it will perform back to normal but the moment you brake the vehicle will loose power again. the diagnosis came and said the pump needs attention.
My np300 yd25 engine will get a little bit stuck on rev 900-1100 and rev slow and after that it will do perfectly... When driving when going over a bump and the rev goes below 1 especially on gear 2&3 it will rattle also when when loaded on a small hill it will rev down and will turn off forcing me to use 4wheel drive high what could be the cause and how can I resolve it? Thank
Can i ask why my nissan navara sometimes dosnt go up to 3 abortail what is the prob i put a new injectors i changed the old one and again i have problem with power aometimwa goes good sometimes stops please help me
I have nissan naavara d40, my problem is that after traveling for almost 40k my truck begins to lost power and emit black. I have cleaned fuel tank, change fuel filters but still the problem exist..thanks for any advice...
hello, i replaced fuel flow control valve, remove fault with computer, but after test drive same fault occurred and same things happening, no power etc, where to check whats wrong?
@@Mr330d yes u are dead right, do u watch salvage rebuilds uk? When they stripped the Mercedes GLA I was shocked that it was Renault rubbish! I will stick to my Audi allroad loved them last 15 years!
Hi guys, I have Navara d40,2010, we replace clutch and after that rev not go above the 3000. Attached the scan tool it’s shows code PO335, crankshaft position sensor ,any idea to solve this issue, please advise me. Thanks
hello i have an pathfinder 2006 also without DPF, i have no error on the tester but it does not make pressure on the intake, it has a very low vaccum pressure in the pipe that enters the selenoid sensor, i verified the pipes, there are ok, can you tell me what should i check next ? Thank you !
Actually hard to say because I already forgot about this car so I can tell you perfectly I hope you will try and Google maybe find some picture thank you very much
@@modrix I know what the cooler is.. mine has a hole in the heat exchanger and I just can't find one to buy, at a sensible price atleast. Nissan wants crazy money for it out here in Botswana ($1,400).
@@mompatimase167 yes I believe you once I try to buy in Nissan dealer cabin Fan motor and they said to me 500 euros but I both in China AliExpress for just 80 Euros
@@modrix my care rev reach only 2000rev per min. Dpf had an error p2002 n i cleared that what else can i do pls. When i depress accelerator the rev read 2000 rev per min. Pls help. Somalia no engineers for nissan car. Am lucky i have little abt them
i have my nissan navara yd25 d40 it only cranking but not starting ,but if you do hard push it starts well.i took injectors for service and clean fuel tank but the problem still remains the same what might be the problem
My 2009 Navara goes into limp mode when I set off quickly. It shows high pressure system fault code. Other than that there is very little power at low revs until 2500. Hill starts are nearly impossible. Once over 2500 revs it flys along no problem. Could this be a valve issue too??
You did it. Tank U very much 👍👍👍
Awesome video thank you. Great advice also.
we a nissan np300 2.5. the vehicle has no power but if you switch off and on whilst the vehicle is in motion it will perform back to normal but the moment you brake the vehicle will loose power again. the diagnosis came and said the pump needs attention.
Did you manage to solve the problem
Did you solve it, also mine does the same
Replace sensor on gearbox
Clean fuel tank☺
Yes
That's what my Nissan navara problem is
My np300 yd25 engine will get a little bit stuck on rev 900-1100 and rev slow and after that it will do perfectly... When driving when going over a bump and the rev goes below 1 especially on gear 2&3 it will rattle also when when loaded on a small hill it will rev down and will turn off forcing me to use 4wheel drive high what could be the cause and how can I resolve it? Thank
Did you figure out the issue?
Thank you. I was ready to throw away my car
Thank you
Hi, near the SCV is a wire connection , what sensor is there , i have the connection but is not connected to anything
Can i ask why my nissan navara sometimes dosnt go up to 3 abortail what is the prob i put a new injectors i changed the old one and again i have problem with power aometimwa goes good sometimes stops please help me
It is most of the time ur scv.
I have nissan naavara d40, my problem is that after traveling for almost 40k my truck begins to lost power and emit black. I have cleaned fuel tank, change fuel filters but still the problem exist..thanks for any advice...
my nissian x trail is not starting its coming up low rail pressure could this be the problem
I got my scv of ebay for 35usd. In 2018.
Good video buddy
Thanks a lot
Abas
Good advice.
hello, i replaced fuel flow control valve, remove fault with computer, but after test drive same fault occurred and same things happening, no power etc, where to check whats wrong?
EGR valve?
Trade it for isuzu
The sensor.
@@TheDesperato which sensor?
Only a matter of time before that Navaras timing chain snaps, why bother 😂
In fairness the chassis could snap in half before the timing chain
@@Mr330d I’m not sure what is worse, the chocolate engine Or rusting chassis’s ? And now mercedes use that shit!
@@SalimKhan-gk1fh Mercedes x class premium price for rubbish quality 😂 it’s like buying an A180d with Renault 1.5 Dci engine 🤮
@@Mr330d yes u are dead right, do u watch salvage rebuilds uk? When they stripped the Mercedes GLA I was shocked that it was Renault rubbish! I will stick to my Audi allroad loved them last 15 years!
Hi guys, I have Navara d40,2010, we replace clutch and after that rev not go above the 3000. Attached the scan tool it’s shows code PO335, crankshaft position sensor ,any idea to solve this issue, please advise me. Thanks
There's is sensor on the gearbox just need to replaced it.
@@thelonewolf2181 , you are the great. Changed the sensor and problem solved.🙏🙏
hello i have an pathfinder 2006 also without DPF, i have no error on the tester but it does not make pressure on the intake, it has a very low vaccum pressure in the pipe that enters the selenoid sensor, i verified the pipes, there are ok, can you tell me what should i check next ?
Thank you !
Vakum pump
Hello. I don't have a car speed. How can this be?
abs problem
you don't show
how did you take it apart??
I can see a lot of different car with denso fuel system, have same problem
Company's should refuse using their systems, they are crap
Hey buddy. Where can i find that EGR cooler.
Actually hard to say because I already forgot about this car so I can tell you perfectly I hope you will try and Google maybe find some picture thank you very much
@@modrix I know what the cooler is.. mine has a hole in the heat exchanger and I just can't find one to buy, at a sensible price atleast. Nissan wants crazy money for it out here in Botswana ($1,400).
@@mompatimase167 yes I believe you once I try to buy in Nissan dealer cabin Fan motor and they said to me 500 euros but I both in China AliExpress for just 80 Euros
@@modrix thanks very much I'll look it up on Aliexpress..
@@modrix my care rev reach only 2000rev per min. Dpf had an error p2002 n i cleared that what else can i do pls. When i depress accelerator the rev read 2000 rev per min. Pls help. Somalia no engineers for nissan car. Am lucky i have little abt them
Where that part go?
HP pump
You're explaining to tech people. Try to explain to users
876 peugeot 206
Blah blah blah n even didnt show the doing job!
$40 on ebay
ua-cam.com/video/SzcPm2Ydl58/v-deo.html
I hate DENSO so much
P
Like n sub yol
Why not show where the suction control valve is on the motor
i have my nissan navara yd25 d40 it only cranking but not starting ,but if you do hard push it starts well.i took injectors for service and clean fuel tank but the problem still remains the same what might be the problem
Check your glow plug relay. Try direct heat and crank it
My 2009 Navara goes into limp mode when I set off quickly. It shows high pressure system fault code.
Other than that there is very little power at low revs until 2500. Hill starts are nearly impossible. Once over 2500 revs it flys along no problem. Could this be a valve issue too??
Yes
Suction control valve by diesel pump, expensive but sorts the limp mode issue out