SIEMENS IQ300 DRYER SENSOR CLEAN & REPAIR

[@REAPAIRINSTRUCTIONS]

✔ IF MY VIDEO HELPED YOU, YOU CAN SUPPORT ME WITH A SMALL DONATION.
💰 PAYPAL: www.paypal.com/donate/?hosted_button_id=S4BRFFZQ3C4DJ
🎁 Amazon wish list www.amazon.de/hz/wishlist/ls/22NRWTNXY4RY0?ref_=wl_share
💰 PATREON: patreon.com/user?u=83863251&Link&
💌 [e-mail]

[@peter572]

The manual describes sensor cleaning without plastic removal. Would that be sufficient?

[@REAPAIRINSTRUCTIONS]

In most cases it is sufficient to clean the sensor from the outside without disassembling it. If the problem persists, it must be disassembled.

[@stellavirginia9606]

I will try thistle

[@johanvanelk2802]

This is a look from the inside of the IQ300 with the drum removed, I guess? So how do I access it without the drum being removed?

[@REAPAIRINSTRUCTIONS]

When you open the door and reach into the drum, the sensor is at the bottom. It's just very difficult to see and film. The sensor is located behind the lint filter in the drum

[@dejantancic]

What if when i plug dryer and start ticking noises and nothing on display can’t start just beeping sounds all time like clock? Siemens iq300

[@REAPAIRINSTRUCTIONS]

I'm guessing there's a defect in the controller.
The IC chips often cause problems.
These are marked LNK or TNY. Often a resistor is also defective.
This problem occurs with many manufacturers. Whether washing machines, dryers and dishwashers.
Take a look at this video
ua-cam.com/video/6w_4aup_xYI/v-deo.htmlsi=RwOEL1CCIOQ4Z645