Thank you! I got a Buick with a 3.8 that is about to get some valve work done now. I have a certified mechanic with me while I make this attempt, but I like to go into projects well prepared.
Peter, i have problem with a engine valve in cylinder 3, the valves for my car is a expensive, exist any problem if only replace the damaged valve or do you think i need to replacement all the valves?, the engine not shows a big problem according to my mechanic is a minimum compression issue. Great Video Peter
i heard all the time that those bolts( cam shaft bearings bolts) have to be loose in secuency true or false Pete? in the opposite way that you tide them.
4:30am here and I’m learning to do valves/springs/retainers in my racecar before I hit the time clock for the day! Thanks a lot! Very quality video!
Glad to help
Thank you! I got a Buick with a 3.8 that is about to get some valve work done now. I have a certified mechanic with me while I make this attempt, but I like to go into projects well prepared.
Nice work!
Great video, thank you so much for posting this. I will have this running when I do this job myself
Thank You my Friend. :-)
did you replace these because of a ticking/tapping noise?
Peter, i have problem with a engine valve in cylinder 3, the valves for my car is a expensive, exist any problem if only replace the damaged valve or do you think i need to replacement all the valves?, the engine not shows a big problem according to my mechanic is a minimum compression issue. Great Video Peter
Hi, you can use old valve.
i heard all the time that those bolts( cam shaft bearings bolts) have to be loose in secuency true or false Pete? in the opposite way that you tide them.
Ok. This my way works too.
thanks for this Peter ...
Great. :-)
Thank you very much distinctive educational channel learned a lot Thanks again
Thanks and You are Welcome. :-)
You mixed up the bearings though.Each bearing is specifically machined to that surface correct???
No. Toyota use standard size.
Does engine need to be out to do this?
just the head so it can clamp onto the bottom of the head and the top of the head..
👍
Eli, kun venttiili vaihdetaan uuteen, tarviitseeko kannen pohja hiomista, että uusi venttiili on tiivis? karsta, kuluminen....?
Only new valve and all corrosion remove
How much time does it take to replace it?
About 6 hours
Flat table 10mm wrench and a flat head screw driver same result in fraction of the time
Noted 👍
Great Job Thank You!!!
Thanks for feedback. :-)
keepers are togh/ i used grease dont fall.
Noted 👍
Great vid, but him saying away instead of off erks me lol
You are welcome Sir. :-)
Ignore the stupid comments Pete
very thankful Peter \0/
Thanks :-)
part number for tool please?
very tricky keepers iused grease isit ok.
Noted 👍
thank y ou
Thanks and You are Welcome. :-)
It's hard to understand you Mr.
noted