Bmw e39 "limp" mode and slow acceleration fixed.

So recently my bmw 528i e39 went into a type of limp mode out of now where. The car could bearly accelerated and wasn't drive able. In this video I figures out my problem. Hopefully this video helpes.
Edited by VideoGuru:videoguru.page...

[@jesro94]

❤❤❤ dude that’s dope man

[@GutoNation]

Thanks from Brazil man ♥️

[@aimanalqasimi4927]

How this device works, from which the wire comes out

[@aimanalqasimi4927]

I have a problem when the car is at a complete stop and I press the accelerator pedal, it does not go quickly

[@canadianrust2652]

Could be mass air flow sensor also could be throttle position sensor. Or maybe the idle air control valve

[@priscillawilliams6399]

Burnout ❤ it!😊

[@eduardocovaci1175]

How did u kno your car e39 was în limp mode?

[@canadianrust2652]

Didn't exactly know it was limp mode but all the googling I did suggest that was the problem since I could mat the gas and it didn't Rev much past 3000 rpm, and took a good while to get to 3000 rpm while under load.

[@ayouboun5017]

My e39 have that cable removed is that bad or good?

[@canadianrust2652]

Good if you don't want that to happen. Bad if you want traction control..either way, it won't hurt

[@daveunbranded]

You also have vacuum leaks. The only way a car would run without mass air

[@canadianrust2652]

I'll look into that