Seems like a simple solution would be to just print each piece out seperately and then use the option at the end of the print, to print it again. It would maximize quality of results. Yes, it probably will take longer overall but it will provide best results if what your printing is important.
Thanks. Yes, I know that, but the goal was to print multiple pieces overnight without any manual action needed. That works only layer by layer and not piece by piece. I mean it works, but you have to be super super super careful to make sure that the cross bar is not hitting any printed model. IDK why they even offer this option when they don't check for crossbar interference. I've been writing to their support many times, but I think they still don't realize what's the problem and are definitely not willing to change anything. Very disappointing support from AnkerMake till now.
Seems like a simple solution would be to just print each piece out seperately and then use the option at the end of the print, to print it again. It would maximize quality of results. Yes, it probably will take longer overall but it will provide best results if what your printing is important.
Thanks. Yes, I know that, but the goal was to print multiple pieces overnight without any manual action needed. That works only layer by layer and not piece by piece. I mean it works, but you have to be super super super careful to make sure that the cross bar is not hitting any printed model. IDK why they even offer this option when they don't check for crossbar interference. I've been writing to their support many times, but I think they still don't realize what's the problem and are definitely not willing to change anything. Very disappointing support from AnkerMake till now.