This is a short description on the leveling process for most Tronxy Printers with chitu firmware & inductive probe, Please let me know if I messed something up! Thanks. 👍
There is a square on which the bed is fixed. There are two parallel columns. Unscrew the screws and place the two parallel columns higher so that the bed is balanced.
I have solved this problem. I hope that everyone who has this problem, the bed base, should be done in reverse. The 8 screws should be unscrewed and fastened from the top.
Are you a angel
There is a square on which the bed is fixed. There are two parallel columns. Unscrew the screws and place the two parallel columns higher so that the bed is balanced.
That's a common issue with these, try adding a Z axis belt drive system. Less that 15 bucks online. That helps tremendously
The base of the sensor bed can also be lowered and raised
Hi there I'll just got one still can't.get the correct level.. could you please share corner bracket STL...
I have solved this problem. I hope that everyone who has this problem, the bed base, should be done in reverse. The 8 screws should be unscrewed and fastened from the top.
Did you try adjusting the center screws when probing the center?
The problem is when it starts to print the bed drops about a millimeter or 2 it doesn't go the z offset posision