- 7
- 7 338
David
Приєднався 5 гру 2013
Jeeps, Drones, and Adventure!!
Some footage from Gold Mountain, John Bull & “The Squeeze” in Anza Borrego
Just some photos and videos of my 1997 jeep TJ 4.0 Sport, on some of the most well known trails in California!
Music;
Debonaire - Dope
Photos and videos are original content, No rights reserved to music.
Music;
Debonaire - Dope
Photos and videos are original content, No rights reserved to music.
Переглядів: 172
Відео
Stock Honda Accord on Sheep Creek Truck Trail! | Lytle Creek Entry
Переглядів 662 роки тому
My all stock Honda Accord on the trails in lytle creek! Was testing out the active track with my DJI Air 2S! Thanks for watching!
Dana Point Harbor & Headlands 4K Drone Footage | DJI Air 2S Footage
Переглядів 702 роки тому
Dana point, California harbor & Headlands footage with DJI Air 2S! Music; Sierras - Orchard Heights
San Bernardino National Forest Highway 18. | DJI Air 2S 1080/60.
Переглядів 202 роки тому
My first small editorial of videos I collected with my DJI Air 2S in the San Bernardino Forest off highway 18 at 7AM. Enjoy! Music: Falls - Keith Kenniff
Leveling Your Tronxy X5SA
Переглядів 7 тис.2 роки тому
This is a short description on the leveling process for most Tronxy Printers with chitu firmware & inductive probe, Please let me know if I messed something up! Thanks. 👍
EF Civic Spirited Downhill Driving. | Lytle Creek
Переглядів 1305 років тому
B20 SiR Trans non LSD Fun cruise, first time up in a while!
David’s EF Hatch
Переглядів 286 років тому
Instagram : duhvidd My ED Hatch! B20 SiR Trans, More videos to come soon! No hate in the EF community!!! 🤙🏼🤙🏼🇯🇵 (Only put EF because of widely known Chassis, it’s USDM!) Let me know what you think! 🤔😃
Are you a angel
The base of the sensor bed can also be lowered and raised
There is a square on which the bed is fixed. There are two parallel columns. Unscrew the screws and place the two parallel columns higher so that the bed is balanced.
I have solved this problem. I hope that everyone who has this problem, the bed base, should be done in reverse. The 8 screws should be unscrewed and fastened from the top.
That was sick! Great vid
Thank you I really appreciate that
That's a common issue with these, try adding a Z axis belt drive system. Less that 15 bucks online. That helps tremendously
The problem is when it starts to print the bed drops about a millimeter or 2 it doesn't go the z offset posision
Did you try adjusting the center screws when probing the center?
Hi there I'll just got one still can't.get the correct level.. could you please share corner bracket STL...
a very nice location and amazing footage ! I subscribe
Thank you so much ! 🙏
Exhaust sounds nice, what is that?
E.F. Insanity thank you man! i was running a 4-2-1 header with 2.5in stainless piping to a DC axle back no left side bend!