If I remember correctly the wire was for a temp sensor, some heads have an extra sensor at the side of the thermostat housing this one didn't. The push button start is the solenoid so there's no need for another. 🙂👍
Absolutely unreal vid mate! Just saved me many hours of trying to workout my new autosparks full loom kit over here in AUS! If your goal was to help atleast one person, youve nailed it!!
Hello, good job!
Could you Telles me where I can find this wiring harness installation guide? If you can share
Hi, there is no installation guide available, I use a combination of haynes and land rover manuals.
Where did that green wire by the dynamo end up going? If you have a push button start does that act like a solenoid? Do you still need a solenoid?
If I remember correctly the wire was for a temp sensor, some heads have an extra sensor at the side of the thermostat housing this one didn't. The push button start is the solenoid so there's no need for another. 🙂👍
Good job Craig! Love to see a video of you driving it around the estate when it’s finished 🙂👍
Will do pal and hopefully soon 🤞🤞👍
Was there a part 3?
Hopefully, there will be. The owner came and collected it before I had a chance to finish the video I'll try and and do it in the next few weeks. 🙂👍
Thanks for taking the time to do this video, very informative.
Great to see you doing videos again, you're a great help and I have the loom to install on mine so any information is welcome! George
Thanks George! I'll try an put as much detail in as possible. 🙂👍
Absolutely unreal vid mate! Just saved me many hours of trying to workout my new autosparks full loom kit over here in AUS!
If your goal was to help atleast one person, youve nailed it!!
Thank you👌 Hopefully, I'll have part 3 of the install vids ready next week it's about time I got it finished 🙂👍
@@retro.restorations Shithot mate that would be unreal :) looking forward to it and have subscribed :)
Hier in Nederland ook. Top video thx.