Dead engine block Detroit diesel 12.7. cilinder liner milling
Вставка
- Опубліковано 4 жов 2024
- This video shows how to restore the geometry of the seats in the Detroit Dizel 12.7 engine block. These engines are highly susceptible to corrosion under the liners and the subsidence of the liners, resulting in punching the gasket of the block head. The protrusion of the sleeve from the factory is quite low: somewhere from 0.0 to 0.03 mm. over time, the upper shoulder of the sleeves loosens, an access of antifreeze is formed, which in turn accelerates the process of destroying the shelf in the block. The factory tolerance for the ledge is from 0.00 to 0.076 mm in terms of inches. I try to make the ledge higher in this limit. In this case it was cut off in the order of 0.44 mm for laying of repair washer, whose thickness is 0.5 mm. the Block was milled in two passes. I had to mill blocks and one and a half millimeters, but in this case, Customers prefer not to remove everything completely, but only to align the geometry and lift the sleeves. After this procedure, the equivalent protrusion of the sleeves relative to each other is also achieved. I would like to note that I do not really want to cut deep enough because of the constructive selection under the shelf (I shot it separately in the video).
==============================================
This procedure is desirable to perform with all six holes, this is stated at the end of this video. • Опять пробило прокладк... #MOTORIST #DALNOBOY
Спасибо, видео понравилось, супер!!!!!
Непойму откуда сотки возьмутся с такой приспособой
Посадочное с трещиной напрягло,некисло блок кавитация поимела.
Выступание гильзы из блока 0,08мм это под стальную многослойную прокладку? На американских роликах они оставляют 0,35мм под клингеритовую прокладку.
Вот это интересно. Сколько всё-таки на паронитовую надо выступ
👍✌️
а где кольца берете?
Здравствуйте в каком регионе вы находитесь, как с вами можно связаться
Подписался)
Отлично! 👍
MOTORIST нельзя игнорировать просьбу специалиста такого высокого уровня 😂
Где такой станок заказывали.
Зачем на этом машинке провод всеравноже рукой крутиш
У нее в основании электромагнит. За счет него она держится.
А на isx реально выточить?
Теоретически на территории СПб могу. Фрезу надо просить другую.
Долго ходит после проточки?
Да, долго.
Сколько раз можно на резать блок дд
Никто точно не скажет. Миллиметра полтора можно.
@@MOTORIST78 а как эта штуковина центрируется по отверстию?
@@MOTORIST78 а где же взять такие толстые кольца, или можно подкладывать несколько колец?
@@НиколайФилимонов-м7э я думаю из листа нержавейки на лазере заказать
@@magferson просто так на лазере я думаю не пойдет, надо плоскость шлифовать