Thank you ,very patient,explicitly and so clear the video.,when I'll be ready to do it .I just show the new starter, your video and it going to replace by itself. Pet from Hialeah Fl
For the wire plug that requires the harness to be squeezed. Just take a long screwdriver or strong thin rod. Place it in under the top of the clip. Place the other end against the exhaust and just push I'm and up. Also note the new starter may have a new nut for the positive lead. Be sure to validate the size of that nut before shoving the starter back in. Replacing the starter on my wife's smart car was so much easier than this.
These stupid car manufacturers anf their stupid ass connectors drive me insane!! Plus they make 1,000,000 different types that when doing blindly makes it impossible. Ugh
Thank you ,very patient,explicitly and so clear the video.,when I'll be ready to do it .I just show the new starter, your video and it going to replace by itself. Pet from Hialeah Fl
thank you! the clips were my only problem and you explained well enough that even I was able to unplug!
Always take off Negative first. Goes back on last! Js
Thank you. I learned not to try this. I could theoretically do it, but I don't have the jack or ramps. Auto shop down the street, here I come!
Thank you brother I so appreciate the help wish me good luck God bless in Jesus's mighty love Amen
You make this job look so easy. But everyone in the comments say it such a tight fit and can't get starter out after unbolting
Good job. The snap on connectors are always hard...have to be careful not to break old plastic parts ..thanks
Your videos are very informed.. Good about the difference of the starters
?..
does that goes for the 2003 also
Good Job...TY
Thankyou
I had fun changing my starter on my ford fusion 2006! Manual was easier then the automatic!
If you look at the pos cable you pulled off the starter it has the locking tab
Did this today. 2007 CTS. Everything went great. That Nox sensor is a bitch though. Spent like 5 minutes trying to remove it with my hands.
The locking tap is on the starter, so the battery cable can only be clocked one way
Replaced starter. Starts fine. 3 days later spinning sound, car doesn't start. Need your help
Thanks needed that
Do you know it is the same proccess for an srx of the same year?
It might be. They are front wheel drive
@@JaboTheMechanic yes they are.
For the wire plug that requires the harness to be squeezed. Just take a long screwdriver or strong thin rod. Place it in under the top of the clip. Place the other end against the exhaust and just push I'm and up. Also note the new starter may have a new nut for the positive lead. Be sure to validate the size of that nut before shoving the starter back in.
Replacing the starter on my wife's smart car was so much easier than this.
What sockets and tools do you need?
15mm 13mm and 10mm for battery..
Question how many starters does the Cadillac CTS 2006 have?
😂
Can u do my car next
These stupid car manufacturers anf their stupid ass connectors drive me insane!! Plus they make 1,000,000 different types that when doing blindly makes it impossible. Ugh
You tubers talk tooo damn much about other things smh. Like women
Stop talking so much