Ford Fusion blower motor resistor and pigtail replacement

I was asked to take a look at this 2011 Ford Fusion and figure out why the blower motor wasn’t working. I took a look and found the resistor and wiring harness to be bad. Here’s a look into my diagnosis and repair. Enjoy!
Have anything you’d like to see? Anything you like so far? Ideas for the channel? Let me know.
Subscribe for more!
Channel Instagram: / mpt.yt4
Facebook: / michaeltomko4
Snapchat: / michaeltomko4
Reach out: [e-mail]

[@cowboy26a]

Wife's 2011 Ford Fusion. Blower motor would quit and then restart . I replaced the blower motor and problem still persisted. Watched your video and when I pulled the blower motor resistor I found the same problem. Burnt plug. I could wiggle the plug and the blower moter would run. Ordered the resistor module and plug pigtail. Your video save me a lot of trouble shooting.

[@mpt.yt4]

Glad i could help!

[@markgarduno4597]

Explained clearly and direct to the point. Thank you sir.😮

[@aaronota939]

I looked at about six other videos, that were i strumental, but yours was the golden ticket.
As i unplugged things i would replug then turned the ignition to start the system, and WALA. It worked.

[@williamcreery2631]

Very informative! This Definitely gives me an insight on checking and replacing my blower motor! Thank You!

[@mpt.yt4]

🫡🫡

[@danielj1063]

Nice work, esp catchin' periferals
Thanks

[@mpt.yt4]

Thanks!

[@KaoticGhoul640]

You are a lifesaver, thank you so much for the tutorial, I have AC again!!!

[@mpt.yt4]

Glad to help!!

[@aushaleflowers5890]

This is a great video.. Exactly what I needed

[@noviye6]

That was really good

[@25rangebomb]

👏🏽 perfect video, thank YOU

[@mpt.yt4]

You’re welcome!

[@sebastiansebastiansebastia1076]

Goat

[@LucidVisionMane]

Hey do I need to disconnect the terminals for this? I hear 50/50 from everyone so just wondering if you left them connected.

[@mpt.yt4]

Not sure which terminals you’re talking about, but I only disconnected what I showed in the video. I had to replace my plug end because of how melted it was.

[@LucidVisionMane]

@@mpt.yt4 oh I meant if I needed to disconnect the battery cables before doing this but it’s all good, I had opened the resistor kit and it ended up being the first step on the instructions lol.

[@386DAWG]

Ford Fusion blower motor resistor and pigtail replacement

[@attyahmuaidy3839]

Where can i find the wire ???

[@Mr17shorty]

Part number by chance?

[@mpt.yt4]

@@Mr17shorty Dorman 973057

[@carlenacross4132]

What size screw are those taken out of the blower motor

[@mpt.yt4]

7/32 in