I love the little arduino based gauge set, I've been considering doing something very similar (but more permanent 😅) on my swap. Do you have a video on which sensors you used and such? 👍
Hi, thanks! I do have several videos on the arduino project. I made a video for each sensor if you look back in my videos and then I have a couple update videos of the project overall.
@@OvensGarage your truck is in great shape if you do get gauges avoid drilling into the dash or trim pillars. It's nice to see trucks that have been preserved.
I'm not sure as I got mine used, I didn't have an exact part number. As long as the shaft is long enough (I had to cut and thread mine down a bit). you should be okay.
The blue truck I can tell has a stock pump. The red truck I've done 3200 spring, THD fuel pin, M&H timing spacer, and 1/2 turn from runaway on max fuel screw. I need to bring my starwheel up a bit and back out my smoke screw some. I've got too much zero boost fueling and too much fueling under boost right now. We'll see what sort of performance I can get out of it. I think I'll notice quite a difference. I'm hesitant to floor it in the truck right now because it over fuels and smokes too much. Hoping I can get it dialed in a bit more for performance.
Great video...... you are providing a ton of valuable information for fellow enthusiasts! Keep these videos coming!
Thanks for watching!
Awesome stuff!
Thanks!
I love the little arduino based gauge set, I've been considering doing something very similar (but more permanent 😅) on my swap. Do you have a video on which sensors you used and such? 👍
Hi, thanks! I do have several videos on the arduino project. I made a video for each sensor if you look back in my videos and then I have a couple update videos of the project overall.
Truck sounds good did the egt's fluctuate?
Thanks, don't have an EGT gauge as of yet..still working on my gauge setup...more to come in the future
@@OvensGarage your truck is in great shape if you do get gauges avoid drilling into the dash or trim pillars. It's nice to see trucks that have been preserved.
What is that little gauge screen you had on the floor?
That's a custom built arduino gauge that I made, it's temporary until I finish my complete arduino gauge pod setup.
I just got a hx35 from a 98.5-02 dodge it has the cast elbo on it we’re would be a good place to get the exhaust flange to clamp to my stock exhaust
Should be the same if it's not some of the exhaust places or diesel shops online sell adaptors that you have to weld on
I have the same truck and am looking to order this wastegate. Do you know if I should order the wastegate for the 94-98 or 99-01?
I'm not sure as I got mine used, I didn't have an exact part number. As long as the shaft is long enough (I had to cut and thread mine down a bit). you should be okay.
Preciate it. I ordered the 94-98. We’ll see if I have to do the same
is your injection pump stock? If so you are about to enjoy a whole new world once you tune it.
The blue truck I can tell has a stock pump. The red truck I've done 3200 spring, THD fuel pin, M&H timing spacer, and 1/2 turn from runaway on max fuel screw. I need to bring my starwheel up a bit and back out my smoke screw some. I've got too much zero boost fueling and too much fueling under boost right now. We'll see what sort of performance I can get out of it. I think I'll notice quite a difference. I'm hesitant to floor it in the truck right now because it over fuels and smokes too much. Hoping I can get it dialed in a bit more for performance.
What size of injectors are you using