How To Install Holley's Mid Mount Accessory Drive Kit - EP. 3: 1951 Studebaker Truck LS Conversion

Subscribe now to make sure you don't miss any of our new products!
www.youtube.co...
HOLLEY ON SOCIAL:
Facebook - / holleyperformance
Twitter - / holley_news
Instagram - / holleyperformance
Website - www.holley.com
Product Videos - • Product Videos
PURCHASE:

[@peewee7405]

I love this setup simple easy looks great.

[@RailAlignment]

Very nice. One more thing to put on my Holley order list.

[@projectgattago]

This kit looks amazing. Holley needs to step up and offer a kit for the Gen V LT4.

[@Rocking_B]

Supercharger compatible for the LSA and LS9 would be cool too

[@thatmand4542]

5:49 Cross thread or no thread babe lol

[@ClintonC1991]

My thermostat housing leaks. Was hoping I was missing a gasket but it seems like it just goes in.

[@GarenteedTires]

will I have clearance issues on a LS3 in a 1971 cutlass?? I know the high munt will work but I like this mid mount

[@HolleyPerformance]

I can't answer that question honestly. I have never installed one in a 71 cutlass and there are a lot of variables to take into consideration, are you using Holley motor and trans mounts with cross member?? Best thing is to do a bunch of measuring like how far back and how high the engine is going to sit! Thx J

[@seanlehtimaki9056]

With this kit do I need to use an electric fan only or can I use a belt driven fan?

[@truckerhen2768]

Lol man stop ain’t no fan going on this setup

[@shawrep225]

Will this setup work with a 5.3 LS in a 1988 G Body??

[@duvall408w]

Was looking at ur race mid mount setup.Is there .250 on the water pump mounting point so i can mill it down to fit on motor plate? Do u see and problems milling it down?Thanks

[@HolleyPerformance]

Robert, It is going to depend on your motor plate. the mounting points for the pump have enough material to remove .250" but it will cause interference with the back of the pump on the passenger side near the heater hose outlets. If you can notch a small section of your front plate in a half moon shape, then there should be enough clearance for the plate. Thx J

[@corswikiharris9233]

What’s the part number on that earls steam port kit

[@MrDMV816]

Is this available without the ac ?

[@timothyvoight6886]

Can the crankshaft pulley be pinned?

[@JohnSmith-qj4cf]

Do you have a part number for Kitano the cost$$$

[@nightstorm9128]

Do not use a wire brush on aluminium..buy a toothbrush it will work jizzo..