AEM XSERIES OBDII Set Up in HPTuners Software

Beau from AEM Electronics walks you through setting up the HPTuners software to identify and log AFR data from the X-Series OBDII Wideband Gauge on a Chevy Camaro. He also shows you how to set up two gauges so you can identify them on the channel list if you have one for each bank on a V8. Works with 2008/up vehicles only.

[@andrewn.3660]

I was wondering how I’d install the pair of x series I picked up. Thanks for this video. Cleared up a couple things I needed to know that the instructions don’t. Have a good one

[@chevelleleigh609]

I tried to hook mine up exactly. The gauge works. But when I add the channel it doesn’t work

[@pist0lpete]

What needs to be done to get HP Tuners to pickup native Air Fuel Ratio rather than Lambda?

[@thatafridude]

So what happens when you search it so many times to the extent where it disappears on the channel list (wb eq) cos I don’t seem to find it again?

[@brucemeyer6345]

I followed the instructions in the video but when I connect the MPVI2+ scanner to the passthrough from the AEM wideband, it only reads the wideband and not the car. I have even replaced the gauge and the wiring but it still only reads the wideband. If I remove the passthrough and connect the MPVI2+ to the OBDII port directly it reads the car just fine. Is there some other setting that may be off?

[@eze8024]

Would this wideband also work on a 2005 wrx tuned on opensource via tactrix cable?

[@Patriot-kk2hf]

will this gauge allow the standard hp tuners to have a wideband signal on the hp graph?

[@AEMpowerTVelectronics]

The wideband data will appear in the HP Tuners logs.

[@4drturbo85]

How does the Bosch 4.9 LSU compare to the proven NTK wideband sensors?

[@Ernan302]

Whats part # for 2nd AEM wideband, looks like different obd2 connector than connector on 30-0334 ???

[@andrewn.3660]

It was the hpt mpvi connecting to the bottom of the stacked obd wideband cables.

[@ernestogonzalez7786]

Will this work with LiveLink?

[@sseilmnop]

Do you need the upgraded box for this to work, or will the standard one do fine?

[@AEMpowerTVelectronics]

Please check the HP Tuners forum. There is information there regarding what versions this will work with.

[@RyanMHawkins78]

You don't need MPVI Pro since it runs off the vehicle aldl port.

[@gripinc1515]

I did this and the VCM scanner doesn’t display the data?

[@AEMpowerTVelectronics]

Please contact our tech support team at [e-mail] and they will help you out!

[@HotLlew]

how to use this with Evoscan?

[@AEMpowerTVelectronics]

We have not validated Evoscan to work with the OBDII X-Series Wideband.

[@phillipemark1567]

The music is distracting.

[@koihoshi]

*mashes sony electric piano keys "THE WAY WE HOOK THIS UP IS" *smashes drums and plays trumpet

[@bigbilldelta9935]

Only works on 2008 and newer obd2 CAN Bus. Dosen't show up on my 2003 Silverado

[@AEMpowerTVelectronics]

Correct. The OEMs adopted the CAN standard in 2008, so it will only work on 08-up vehicles.

[@rustindupree2049]

So how do hook the x series to like my 2003 trans am

[@rustindupree2049]

I have pro link cable