BMW R100 S steering Head BEARINGS Replacement with CHEAP TOOLS

Поділитися
Вставка

КОМЕНТАРІ • 16

  • @HDoom.
    @HDoom. 4 роки тому +1

    8:09 The "Aaachhhhh" came from deep within, I felt that :'D

    • @bikedogtor1663
      @bikedogtor1663  4 роки тому

      :D one hand holding parts and something falls down...

  • @bikedogtor1663
    @bikedogtor1663  4 роки тому +1

    It was fun to work this video out because I like it when plans work. Thanks to many good comments in the last video I got the right tool to succeed (even if I had to "change" it little bit as always). I hope you enjoyed this video.

  • @michaelcrenshaw9199
    @michaelcrenshaw9199 Рік тому

    When installing bearings or other metals it helps to soak the bearing in the freezer for six to twelve hours.

  • @andyw7978
    @andyw7978 3 місяці тому

    What was the inner race puller tool? Thanks!

  • @malcolmnash5850
    @malcolmnash5850 3 роки тому

    Hi, how did you remove the and replace the bearings on the Triple Clamp, Thanks Malcolm.

    • @bikedogtor1663
      @bikedogtor1663  3 роки тому +2

      Hi, see this earlier video
      ua-cam.com/video/YC8nonjfdLA/v-deo.html

    • @malcolmnash5850
      @malcolmnash5850 3 роки тому

      Thanks very much for the information and help.

    • @malcolmnash5850
      @malcolmnash5850 3 роки тому

      HI, I'm looking to buy the same set of Bearing removers and was just wondering if you could tell me the size of the hole ( or what size puller you used and grounded down ) of the Bearing that remained inside the frame, Thanks Malcolm.

    • @bikedogtor1663
      @bikedogtor1663  3 роки тому

      @@malcolmnash5850 hey, I ordered the set with different sizes bc it's very useful anyway. If you want to buy this specific size only I can measure it for you.

    • @malcolmnash5850
      @malcolmnash5850 3 роки тому

      Thanks, I'm also going to buy a set but I would like to know that the right size is amongst it, Thanks Malcolm.