2017 - 2020 Hyundai Elantra Amp and Sub Install
Вставка
- Опубліковано 3 жов 2024
- Parts used linked in the description below!
Watch a full tutorial as a 2018 Hyundai Elantra will have an amplifier and subwoofers installed to the factory radio. Note this Elantra was not equipped with the factory amplified sound system.
This video applies to Hyundai Elantra models for years 2017, 2018, 2019, and 2020. This video also includes amplifier wiring, amp installation and testing.
Click here to see how to set your gains on your amplifier!
• How To Set The Gains O...
If you have any questions, leave a comment below! Be sure to like and subscribe!
Parts used in this install (Amazon Associate Paid Links):
*MTX 2 - 12" Subwoofers: amzn.to/3G81j9u
*Planet Audio Bass Amplifier: amzn.to/3fTJw9S
*Pac Audio Line Out Converter: amzn.to/2UcAXjb
*8 Gauge Amplifier Wiring Kit: amzn.to/3iWX7jK
*Micro2 Add-A-Circuit: amzn.to/3GT7kXF
Disclosure: As an Amazon Associate I earn from qualifying purchases
Parts used linked in the description of the video!
Hey I had a question about a sub system I installed in a car…I put it in and everything works but I noticed sometimes when nothing was being played it would randomly make a low rumble sound?? Do you know what would be causing this
@@josiahmoser6347 Active noise cancelation
@@Trisket4266 yea that would be cool
@@josiahmoser6347 Depends on the vehicle, but sounds like it could be ANC playing through the speakers. Can't help much unless I know the year, make, model, amp, sub, head unit, etc. Too many variables.
@@josiahmoser6347 No. I mean the issue is probably your aftermarket amplifier is amplifying the ANC from your factory amplifer. ANC is used to make your Drive quieter by simulating road and engine noise. But Provo is right, no-one can help without knowing the specifics
No..I didn't wanna hear it anyway
do you have the wiring diagram to look at?
Hola los plus de audio solo conectaste a los cables de los parlantes traseros?
Is the stereo touch screen if so how did you wire to it?
He didn't have to, his amp had a high level speaker harness so all he had to do was tap into the speaker wire going to the right rear door speaker. Alternatively you can buy a signal converter that does the same thing ...it allows you to tap the speaker wire in your car and covert to an RCA so that you can connect directly to your amp without having to access your head unit.
It's so frustrating because in Australia, the same car is put together completely different. There's no wiring in the pillars, none. There's no rubber grommet on the engine bay for firewall passthrough. Even all the wires are different colours.
ITS THE WIRES THAT ARE TWISTED TOGETHER MINE ARE BLACK AND YELLOW
@@chrisgambill1390 I figured a heap of it out. Ended up getting everything installed myself, but man it was frustrating. Basically no references.
Question could you by any chance know if the color coding is the same for a 2018 Hyundai sonata SEL?
I got the same setup as you got off Amazon, and I’m trying to install but do you have to add RCA from amp to radio???
GREAT HELP... It worked for me! Thank you!
How would u install line outconverter
Would the wiring for a 2015 Elantra GT be the same as this video? or would it be a different process? i cant seem to find a wiring diagram for it.
Would it be safe to assume that a 2018 Hyundai Sonata is going to be wired the same. Everything looks the same. Do you have a schematic for that car rear b billar as well?
Did that amp come with the high level harness ?
The add a circuit link is a bit confusing to me. If you tapped the spare fuse and it's on ignition switch why do you need the add a circuit. Did you wrap the remote wire around the spare fuse on the left prong? I am just trying to understand before I stalling. Thanks in advance
We made our own add-a-circuit. We suggest you purchase one yourself, and no, we didn't just wrap the wire round the fuse prong. Using an add-a-circuit allows you to pull power from the front of the fuse box safely instead of just shoving the wire into the fuse box. It fuses the run to our own circuit.
@@ProvoBeastAudio okay so with the spare that is used should I pull the spare out and place the add a circuit there? Also would a 15amp one be okay to use that what's at my local store
@@goosem4554 The remote turn on function in most cases will only pull 1 amp or less, so while a 15 amp fuse would work, it isn’t as safe as using a 1 amp micro fuse or the more commonly available 3 amp micro fuse
Does the sub sound good in the trunk? Cause I have a smaller 10 in and i don’t feel bass in the trunk unless I put it in the back seat
Way too many variables there. Most likely you don’t have the right sub paired with the right amp on the right electrical. Can greatly vary based on the signal it’s getting, where gains are set, etc. lots of variables.
You said you ran the remote turn on wire to the amp… where does the remote turn on wire come from?
I'm tapping into the rear speakers on my 2018 Hyundai Elantra but it doesn't have a brown cable. Which cable should I tap into?
Same thing I am trying to figure out smh
@@PvtSaunders it's the wires that are twisted together. Mine were black and white.
I have a 2017, how do I know if I need a loc
Do you need an amp to set up a subwoofer? I’m trying to install subwoofer to my 2023 sel elantra and I can’t seem to find videos on it other than yours for the previous models, if possibly how would I be able to setup just the subwoofer?
You need an amplifier for a subwoofer. For specific help, feel free to send me a message on our Facebook page.
@@ProvoBeastAudio which amps are recommended/compatible for the sel 2023 elantra ?
@@angelcastaneda0297 You don't base the amp really on the car, you base it on the sub itself. If you want some recommendations, sent us a message on our facebook page and I can send over some great recommendations!
How did you tune it for clipping?
Using an SMD-DD1
How did you get the panels off
Are the wire colors the same on the base GT model?
Where is the factory amplifier is located??.
I doubt it has a factory amplifier in this particular car that isn't a part of the existing stereo
Are the steps similar for a 2015 elantra?
🙌🏽clutch
Have you done a high output alternator on a 2017 or 2018 Hyundai Elantra? I currently have two skar evl d2 12 on a cab 2200 and a Rockford fosgate 500.4 for my door speakers. I also have a spare agm battery in the trunk that powers the cab 22. I want to eventually get a cab 4500. I just know with the stock alternator it won’t be enough. I know I can get an alternator fro brandX but I worry about the vehicle ecm. I know I need to do a big 3 but the negative battery terminal on the main agm has some kind of fuse attached to it. If you have any videos of that I would appreciate it. I can’t find any videos of that for my 17 Hyundai Elantra.
I have the same car I highly suggest you get either a lithium battery your stock alt will be enough to keep it charged as long as you don’t hook them together then you’ll have a battery entirely dedicated to your sound. I’ve been looking for an upgraded alt but they are hard to find for this car. Was running 2 vxfs of a 3k in the process of swapping to 3 10s so that should be plenty assuming you have an amp matching the evl
@@256jayy3 I have an agm under the hood. I hooked up another agm in the trunk that powers the cab 22. My agm under the hood powers the car stuff and I have a 500.1 for my door speakers. So you think I should get a lithium under the hood and in the trunk? Even with that I would like to get a 4K but would I still need to get a high output alt? Brand X says they can make an alt but I heard that with the cars computer it still would not let the battery charge above 12 volt.
How big of a amp can you put on that stock alt?
Depending on your engine size, factory alt puts out about 120 amps max, so between the factory electrical draw, and the additional draw of your amplifier, you are safe for around 1000ish watts RMS (70ams) before more upgrades are needed. Be sure to have a healthy battery.
Great video
Is the 2022 the same process?
Similar, yes!
Good video. I have the touchscreen in this year model want to run an LC7I. I have to tap to all speakers can I access all speaker wires on that b piller? Or does that just hold the right speakers ?
When I turn my car off, and my stereo still is on
My amp stays on too, as soon as I plug in the speaker from the door, it stays on and wont shut off, my amp has high level imputs also, did you get yours fixed?
That's why he wired the remote wire to an appropriate fuse in the fuse box. Not all of those fuses lose power when the car shuts off. Did you look up which fuses to tap into?
@@Peaches-N-MangoI have my remote turn on into a line out converter. Where should I tap in to run it up to the fuse box
Is this install similar to a 2020 Sonata?
First!
Does this apply to the 2021 model as well?
Body style is different, technique will be the same.
Does the car have a factory amp?