Opening up the Sawmill Edger

[@chrispeters4405]

outstanding work. Im gonna use a lot of that to build mine, my sawmill sits on a 28' salvaged rv trailer with tandem axels. about 6' wide. the tracks to the bandsaw occupy about 30 inches leaving the whole other side of the trailer for an edger. glad you posted this up. Ill be definately using the windshield wiper motor tips. the rollers on 45 degrees absolutely critifcal detail.

[@pup734]

You are genius to build this. Now I will have build one this winter.

[@jimhammer2012]

You're so talented! I'm sure you built it exactly how you wanted so it will do exactly what you want. Thanks so much! Jim

[@realsouthernexposure3957]

Yes, thank you

[@bradjacobs1567]

Have u made up any plans for this build yet I would like to build one. If not could you give me some of the main measurements and sprocket sizes

[@generhodes8634]

nice edger. do you have a supplier for the saw arborshaft and bearings ? thanks for showing your talents

[@realsouthernexposure3957]

Bearings i got from surplus center.com and old industrial i found in a junkyard. Arbor Shaft, I think i milled that one myself.

[@SuperHurdman]

You should do some plans to build the unit!

[@realsouthernexposure3957]

That is a great idea. Thank you

[@pup734]

Hi love the build I would like to know the the tooth count on the sprockets if you don't mind sharing. thanks

[@realsouthernexposure3957]

Drive sprocket for feed rollers #40 @ 11 tooth, feed roller sprockets was 14 tooth. I got a lot of the parts i didn't have on surpluscenter.com, they have windshield wiper motors there too. hope this helps.

[@pup734]

Thanks I used surplus Center when I built my saw mill thanks again

[@coldspring624]

Nice build...

[@realsouthernexposure3957]

Thanks!

[@haroldhinkle5750]

Mark galic where I found you