air fryer not working

Поділитися
Вставка
  • Опубліковано 23 сер 2018
  • you can see the unit turns on but that the fan doesn't work. we turn it on, let it run for a bit, showing the fan not working. then we turn it off showing the fan not running during the cool down cycle.

КОМЕНТАРІ • 31

  • @aadesina163
    @aadesina163 4 місяці тому +1

    If anyone has this issue, first use ya hand to spin the lower fan as is and see if it moves freely. It might be grating against the cooking chamber roof and that stops it spinning freely. If that's not the issue, disassemble the fryer and check the upper fan is not obstructed either.
    Then check the power printed circuit board and the specific connecter into which the fan motor wire connects. Remove and plug it back in (could be loose fan motor wire connection). Also check the solder joint holding this connector to the actual pcb (where it sits on the PCB).
    Then use multimeter to check the connector on the PCB has voltage when the fryer is turned on. To do this, you put the positive multimeter lead on the fan motor connector and the negative lead on ground (you will see it marked on the fan motor or PCB as 'GND').
    If there is voltage (it should be about 5 volts), check the fan motor itself is not faulty.
    I know a lot about air fryers. Repaired many more than I seen reproductive organs of the opposite sex... Hahahaha😂😂😂

  • @mazeg2109
    @mazeg2109 5 років тому +10

    I have the same problems fan not working but everything else is working.

  • @g4joe
    @g4joe Рік тому

    It will be the Thermal fuse. Its by the motor. Lots on youtube "how too fix it" good luck 👍🇬🇧
    Thats for the Fan.
    If it will not start check micro switch for the pan. 👍

  • @jovegairy8409
    @jovegairy8409 Рік тому

    Thank you. It works successfully!

  • @lemonssantonio
    @lemonssantonio 4 роки тому +1

    Thanks a lot for this video I just fixed mine back to cooking.

    • @krooldude1970
      @krooldude1970 4 роки тому +5

      I have the same problem. How did you fix it?

    • @MrThing-md8ks
      @MrThing-md8ks 2 роки тому

      @@krooldude1970 You may not be putting the basket in correctly so angle the basket up a little when you're putting it in

  • @BoDiddly
    @BoDiddly 4 роки тому +1

    Yep! I have the 6-qt and the fan stopped spinning as well.

  • @danielwhiting1454
    @danielwhiting1454 7 місяців тому

    Cheers mate your a star merry christmas

  • @EJ-qh6np
    @EJ-qh6np 5 років тому +3

    Did you find out what the problem was or exchange it? I have the same problem.

  • @TheDrJ2006
    @TheDrJ2006 3 роки тому

    Good thing i got an air fryer oven that has its fan spinning and the fan wobbles a bit.

  • @aprilcollier2866
    @aprilcollier2866 5 років тому +2

    Mines heating up too but the fan not working what can I do

  • @DareToBeMexox
    @DareToBeMexox 5 років тому +4

    Try tightening the fan, mine was loose !!

    • @agossett9
      @agossett9 4 роки тому +1

      this is the solution! thank you Kyla!

    • @jacquietran3349
      @jacquietran3349 4 роки тому +1

      How do you tighten it?

    • @agossett9
      @agossett9 4 роки тому +2

      @@jacquietran3349 remove the basket and then once the basket is out you can see the fan above. There is a nut that holds the fan in place and you can tighten using a socket wrench. Just make sure to use something to keep the fan from spinning while you are tightening the nut.

    • @dylanboone7791
      @dylanboone7791 4 роки тому

      Same thing watched video , tight end up fan works great

    • @richielivz
      @richielivz 4 роки тому +3

      I tightened the fan it still isn't spinning.

  • @jamilmjq
    @jamilmjq 3 роки тому

    how you fixed this, Please tell me

  • @jimr2807
    @jimr2807 3 роки тому +1

    My problem was the unit not turning on at all. I found that the "knob" under the basket wasn't making contact; I'll have to put something in it for connection, but I'm happy!

    • @joeychanco
      @joeychanco 3 роки тому

      hi how did you do this? mine is not turning on:( Thanks

    • @jimr2807
      @jimr2807 3 роки тому

      @@joeychanco we rolled a small piece of parchment paper and wedged it in the front slot; if your machine is plugged in, the power light should come on. You can experiment with the switch in the front of the base, but it works like a charm! (If you need a pic or anything else, please let me know)

    • @joeychanco
      @joeychanco 3 роки тому

      @@jimr2807 Great will work on this thank you

    • @victoriacarey5378
      @victoriacarey5378 2 роки тому

      @@jimr2807 I may have to do parchment paper instead of paper towel. Either way work but paper towel sounds like a fire hazard. Thanks

  • @rashaalsaad8418
    @rashaalsaad8418 3 роки тому +2

    My problem is the fan work but the heat not working stay cold

  • @lamontmajor5055
    @lamontmajor5055 3 роки тому

    How you fixed it

  • @veralemes7161
    @veralemes7161 5 років тому

    I have the same problem.

  • @davontaerellmore1183
    @davontaerellmore1183 3 роки тому

    My shit no heating up

  • @debbierummage4508
    @debbierummage4508 3 роки тому

    No