HOW TO: 2013 Hyundai Tucson Oil Change

Поділитися
Вставка
  • Опубліковано 1 бер 2019
  • HOW TO: 2013 Hyundai Tucson Oil Change
    Rhino Ramps: amzn.to/2Hc7Kw2
    17mm Wrench: amzn.to/2TbBFvv
    Castrol Edge 5W30 Syn: amzn.to/2T9WG9S
    Castrol Edge 5W30 Syn High Mileage: amzn.to/2EJmXTU
    Fram Oil Filter: amzn.to/2UgQLfV
    In this video I will go over how to do an oil change on a Hyundai Tucson. This video should be representative on 2010 to 2015 years.
    Hyundai calls out 5W20 oil but I prefer 5W30 in the hotter climate of Arizona. First thing you want to do is get the front of the car up off the ground, so that you can get underneath. Position your oil catch pan under the drain plug and use a 17mm to remove. Once oil is dripping, move to the oil filter and remove. Replace drain plug and new oil filter, be sure to tighten both 1/2 turn passed the catch point.
    Re-fill oil, start with 4 quarts and fill until middle of empty/full mark on dip stick. This should be roughly 4.5 quarts.
    Thanks for tuning in, be sure to like and subscribe
    Until Next time, Keep on wrenching!
  • Авто та транспорт

КОМЕНТАРІ • 19

  • @drewbartley7328
    @drewbartley7328 4 роки тому +1

    Just bought one Best Video Seen Thanks Sooo Much !!

  • @ClamChowderSoup
    @ClamChowderSoup 5 років тому +8

    i would not rub it in the old oil but rather get some new oil and rub it in.

  • @josephr.8344
    @josephr.8344 Рік тому

    Thanks

  • @kevincalitri250
    @kevincalitri250 4 роки тому +1

    I've never heard of a drain plug refereed to as a screw before, good stuff

  • @cousin3386
    @cousin3386 4 роки тому

    What song is that ?

  • @juankbunbury
    @juankbunbury Рік тому

    Hey, how many miles did it have on when you filmed this video?

  • @bhavneetsaini7941
    @bhavneetsaini7941 5 років тому +1

    Did the drain plug have a crush washer and I've seen people put oil in the filter before screwing it in. Is it ok to put in the oil filter without adding oil in it?

    • @jaysenp7083
      @jaysenp7083 5 років тому

      the only benefit is having immediate oil sent through to the engine.

    • @jbsgaragetalk1420
      @jbsgaragetalk1420  3 роки тому

      Yes, there is a copper crush washer. It is OK to add oil to the filter prior to installing if you please

  • @Msleelee9487
    @Msleelee9487 3 роки тому

    how did you reset the oil light i have a 2010 model which looks like yours

  • @cousin3386
    @cousin3386 4 роки тому

    Did u have to remove the splash shield for the drain plug ?I looked underneath the car and everything is absolutely covered by the drain by the splash shield

    • @jbsgaragetalk1420
      @jbsgaragetalk1420  4 роки тому

      Cousin 33 Nope! All areas are exposed except the filter. You need to unclip the circle cover

  • @joshuastephens894
    @joshuastephens894 11 місяців тому

    I would say stick with what the manufacturer recommends. Maybe if someone live in a extremely hot area then maybe it would be warranted. Thank you for posting this video.

    • @nikijefferson2217
      @nikijefferson2217 3 місяці тому

      Once your engine is old it will start to burn hot so youll need and heavier weighted oil, otherwise you'll need oil changes more often

  • @Nabudelimirzz
    @Nabudelimirzz 3 роки тому +1

    How many LTR need for Tucson 2013

    • @jbsgaragetalk1420
      @jbsgaragetalk1420  3 роки тому

      It's advertised as 4.5, but I start with 4, warm it up for a few seconds check and keep filling.

  • @MaxyMonto
    @MaxyMonto 4 роки тому

    Will this work for a 2014?