how to open C6 CORVETTE headlights

We show you how to open the 2005 to 2013 Chevy corvette headlights.
Thankfully this is one of the few headlights that has the option to buy the lenses and replace them.
Buy me a coffee:
www.buymeacoff...
Tools that i use everyday to build lights:
Dremel - amzn.to/2uDjjbO
Dremel Flex Tool - amzn.to/38mRpPV
Dremel Quick Release - amzn.to/2tUUcB2
Dremel Diamond Bit - amzn.to/2uFPmaZ
Plastic & metal adhiesive - amzn.to/37cIwXS
Wire Strippers - amzn.to/39thgWI
Soldering Iron - amzn.to/2SFCw4q
Solder - amzn.to/2HgX7qA
Heat Shrink - amzn.to/38qFyAA
Heat Gun - amzn.to/2UJjwVx
Zep - amzn.to/39pqTpd
RetroRubber - amzn.to/38fmsNz
Impact drill - amzn.to/3bASPbN
Videos Shot on:
Canon Rebel T6 - amzn.to/2SGrCf7
Phone Tri-pod - amzn.to/2HceVTX
Amazon prime 30-day free trial link:
amzn.to/3bsdM8t
*These are all affiliate link, I do get a commission from each purchase made from the links*
#ntxglow #corvette

[@Rlayssard]

Nice video "young bloods". Step by step demonstrations was on point.

[@zaccook]

Thanks!

[@richarddobreny6664]

Stretching the byutle is a great idea. You should also address the breaking of the studs, they tend to break all the time, baking soda and crazy glue.

[@zaccook]

those studs are so annoying!! I haven't really found a good way to remove them without them breaking

[@kevitay]

You video ended very suddenly after the clamping part with no further instructions. How long did you leave the clamps on?

[@zaccook]

sorry! just until the light cools off

[@ffcorona]

Do you offer this service? I have a pair that needs the lenses replaced.

[@phoenix21studios]

someone on the corvette forums used to do this service if you can look them up. I personally think I would rather have the mirimoto upgradess

[@ffcorona]

@@phoenix21studios Thanks for your response. I bought the C8 style GTR Carbide Headlights instead. They are exactly like the C8 headlights compared to the Mirimoto's.👍

[@R7300]

At the 2:15 mark my 3 nuts are loctited to the studs and the studs turn with the nut. You ever had that issue?

[@zaccook]

ugh!! I have, I used an inverted Torx bit on the stud and a wrench on the nut

[@R7300]

@@zaccook ok I'll have to try to find a 9mm wrench. I didn't think I'd have room to be able to loosen the nut in that small area

[@R7300]

@@zaccook it worked for me, thanks for the quick reply

[@pjr037]

Why slam them down on the bench tho

[@zaccook]

Gets people’s attention 😅