Volvo Penta mechanical tilt teardown part 1

I created this video with the UA-cam Video Editor ( / editor )

[@dailydesert7603]

How would I be able to hook up a trim gauge to this . I have the same unit

[@johnbarnes1362]

MrRaven57 , I watched you videos on the tilt trim take apart 1and back together very good and very helpful ! I have that very same tilt trim on my 76 Lancer. my question is which way do the bearing cages face? Video 1 shows that the bearings cages (the side with the crimps holding the bearings in) facing down towards the piston ( opposite of the electrical box). Video 2 does not really show the direction of the bearing on the bottom, and the bearing that goes on top of the clutch you cant tell which direction it faces. I know your video is 3 years old I hope you can remember thanks John B

[@MrRaven57]

I don't think it matters which side is up or down.

[@robertjkropp9463]

How do you get the cotter locking pin off the knob flat end that you screw inn at bottom

[@cuesun09]

where did you get the o rings ...part #

[@davidzorro6649]

Hi , I have stripped mine down and found the worm drive that turns the main big cog is stripped, cant figure out hove to remove and replace , any suggestions or vids please ?

[@MrRaven57]

I never took it out . I would guess it e
just pulls out once the large gear is out.

[@jerryhoward7679]

@@MrRaven57 - No. It appears to have two snap rings in there. How can I get to them?

[@radeckiPL]

Hi
Im looking for to buy this for my dp280 with wire box, maybe someone want to sell it?

[@davidflower7828]

Sorry I no longer have that boat. Good luck.