How to Replace Front Inner Tie Rods 97-03 Ford F-150
Вставка
- Опубліковано 19 чер 2017
- Buy Now!
New Tie Rod Set from 1AAuto.com 1aau.to/ia/1ASFK00451
1A Auto shows you how to repair, install, fix, change or replace loose and worn tie rods. This video is applicable to the 97, 98, 99, 00, 01, 02, 03 Ford F-150
🔧 List of tools used:
• Complete Metric Wrench Set 1aau.to/oiz/1AXAA00010
• Complete Metric Socket Set 1aau.to/oj5/1AXAA00043
• Blowtorch
• 3/8 Inch Breaker Bar
• Torque Wrench 1aau.to/onM/1AXAA00044
• Floor Jack 1aau.to/ok9/1AXAA00068
• Jack Stands 1aau.to/omc/1AXAA00065
For More Info visit us at 1aau.to/h/awx/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√
Ball joint separator tool works awesome for getting stuck tie rods out.
Instead of beating it apart you could've jerk the steering wheel it helps wiggle the two rods apart or try jacking the tire instead of having all the weight off of the tire
Do you guys have a videio or could you do one for the 04-08s? Thanks so much you're vids have helped me out alot
Hi I have a 97 Ford F150 and I was doing the inner tie rod on my front I did manage to get the tie rod end out of the holding bar but then I had a hard time getting the jam nut off of the tie rod in the old tie rod end I had to put it in a vise and then I could not get the Jam nut to go onto the new tie rod end I'm thinking that I could get a screw from the hardware screw might be metric give me a comment if you can, and I have yet to see if the new tie rod end will fit in the sleeve give me a comment back if you can thanks
Nice to see someone else believes in Kenda. Those Klever M/T's are great! And a great price!
Torque specs for the tie rod ends not needed or ?
What type of grease is used to put in tie rod with zerk fitting?
I have the inner tie rod bolt stuck in the center link I had to cut the tie rod end off ... do you have any idea how to drill though that bolt
Both sides are the same process?
Will a bad tie rod cause shaking while driving
Is this the same for 02 crown Vic
Did you leave off the boot
Do u have to do both sides or just the side that is damaged?
you absolutely did damage to the other components in the steering by hitting it that way
I don't have a torch and I'm stuck😩
beating on and heating steering parts is not the proper method
Is that adjustable wrench SAE or metric? heheheheeh
I would clean it first and then proceed with the work, a lot of grease everywhere.
cotter pins are for bozos