I just see one possible problem: When you launch the boat, will the trolling motor hit the roller on the trailer when it drops down? Oh, BTW, thanks for the tip about over tightening the prop nut. I made that mistake and I think maybe that is what caused the shaft bearing to pull out of position and start making noise.
Excellent Vid. I just purchased the same motor and quick release bracket. You got me anxious to install it.
I'm doing the same install on my boat tomorrow. Thank you for your detailed instruction.
Alhamdulillah. Very good.
I bought this model for my 14 ft Jon boat.
Thanks for the video and information. Would like to borrow that wrench
Did you use the same 50 amp breaker from the factory or install a bigger one?
Hey did you cut the plug from Edge and just connected to the new terrova wire? It doesnt matter that is 10gauge and plug is 8?
Great video, thanks!
Nice informative video my man!
Looks like you used the front fish finder wiring for the puck, what will you use for the fish finder wiring? I just got the terrova!
Muy buen video y bien explicado
Does the heading sensor need to be on a switch to turn it off?
Runs good but you need a battery that’s a little bigger than they say
Mark did you go with the 24 or 12 volt, Also did you go back with 45" or if not what length shaft?
Thanks for another great video Mark. Now go fish!
I just see one possible problem: When you launch the boat, will the trolling motor hit the roller on the trailer when it drops down? Oh, BTW, thanks for the tip about over tightening the prop nut. I made that mistake and I think maybe that is what caused the shaft bearing to pull out of position and start making noise.
Front deck could use some adhesive EVA Foam just like the rest of the deck . its cheap enough on Amazon
Do a review on the Terrova.
Hey Mark How is the quick release holding up 2 years later? Any cracks, rattles? Thanks.
What length shaft did you use? If you use a longer that 45" what was the reason?