Hello there, and thank you for watching. so if you look close enough in the video, I can't remember if I changed between linear and deggressive. however, the deggressive will take a deeper initial cut, and then the closer it gets to the bottom of the thread, the lighter the cutting pass will get until you reach the final depth of the threads. The linear motion will take equal depths of cuts until it reaches the final depth of the threads. It's funny that you had just commented on this specific video because my students had a part with 3/4-10 threads, and we set it up on no time.
@@aaronrunk4209 awesome thank you so much for the reply! I gave deggressive a shot at work when chasing the threads for a ballscrew nut and it cut the time almost in half! We used to do .001" per pass and it would take 2+ hours for some of them. :) Love your videos keep them coming!
با سلام و تشکر از شما که می خواهید کمک کنید. من می گویم که من این برنامه را فقط برای استفاده آموزشی ساخته ام. با این حال، اگر در آینده با چیزی که بیش از حد سرم است برخورد کنم، مطمئناً با شما تماس خواهم گرفت. باز هم از تماشای شما متشکرم
Since this style controller is only one I've programmed on I can't say yes and I can't say no however I would say that it should be compatible throughout different series
Hello, what’s the difference between linear and degressive in the threading program?
Hello there, and thank you for watching. so if you look close enough in the video, I can't remember if I changed between linear and deggressive. however, the deggressive will take a deeper initial cut, and then the closer it gets to the bottom of the thread, the lighter the cutting pass will get until you reach the final depth of the threads. The linear motion will take equal depths of cuts until it reaches the final depth of the threads. It's funny that you had just commented on this specific video because my students had a part with 3/4-10 threads, and we set it up on no time.
@@aaronrunk4209 awesome thank you so much for the reply! I gave deggressive a shot at work when chasing the threads for a ballscrew nut and it cut the time almost in half! We used to do .001" per pass and it would take 2+ hours for some of them. :) Love your videos keep them coming!
@moodATM that's great that it helped. Thank you again for watching, and I'll try to get some more together.
سلام تراش کنترل زیمنس دارم میخواستم برای برنامه نویسی قطعه راهنماییم
با سلام و تشکر از شما که می خواهید کمک کنید. من می گویم که من این برنامه را فقط برای استفاده آموزشی ساخته ام. با این حال، اگر در آینده با چیزی که بیش از حد سرم است برخورد کنم، مطمئناً با شما تماس خواهم گرفت. باز هم از تماشای شما متشکرم
When pressing teach TC position
Error 61243
(Tool tip in retraction area.)
But is Z+ 300
X+50
If going off work.
It OK.....
The first page where you set the location of the TC position. Try moving away from the part several inches and try again
Does this work with a Simens 840C control?
Since this style controller is only one I've programmed on I can't say yes and I can't say no however I would say that it should be compatible throughout different series
you have ser set Tool and set work ser
Yes you will set both
Hi
THAT IS WONDERFULL , BUT IF IT WAS IN MERTIC SYSTEM IT BE BETER
Metric does have pros when it comes to programming. Thanks for watching