I know you had upgraded your 07 to 2018 cluster, want to see if you still have 2014 cluster for sale? Would love to put this in my newly purchased stock 2013 cluster
hello sir, i am trying to do like you did with an Kia Morning Instrument Cluster, I did send the can massages, but notthing happen, the can H and L of the Intrument cluster not seem to work because i couldnt see any signal. Your wiring would help me so much, tks alot.
@@ColgroveWay all Toyota networks are 500k. The ID really just identifies which ecu broadcast the message. The bytes in each message control data/function
Controlled in a CAN message. One byte sets coolant temp placement. Changing byte value from 0-255 (0x00-0xFF) moves the gauge. Seems to work on a range of 38C to 120C
I know you had upgraded your 07 to 2018 cluster, want to see if you still have 2014 cluster for sale? Would love to put this in my newly purchased stock 2013 cluster
Where did you get the CAn iD`s and data that you sent?
hello sir, i am trying to do like you did with an Kia Morning Instrument Cluster, I did send the can massages, but notthing happen, the can H and L of the Intrument cluster not seem to work because i couldnt see any signal. Your wiring would help me so much, tks alot.
What is the baud rate used in 2nd gen tundras?
Are you sniffing to get the CAN IDs and then trial error to find which id changes which value?
@@ColgroveWay all Toyota networks are 500k.
The ID really just identifies which ecu broadcast the message. The bytes in each message control data/function
Can you do this for the 2018 -2021 toyota tundra cluster?
@@RustyHoward-l5w yes I have a full gateway I built to run a 2018-2021 cluster on an older truck
Exelente....como encontraste la dirección de cada objeto del instrumental panel? O son estandart?
any link for the instrument cluster to buy?
How did you find the CAN-Bus wires for your cluster? Still struggling with mine.
Wiring diagrams from Toyota. Pin #39 CANH and Pin #40 CANL
@@07trdpro6 Uh well, Mine is a VW Routan gauge cluster.
how to simulate coolant temperature movement? Also Using PWM? Many thanks
Controlled in a CAN message. One byte sets coolant temp placement. Changing byte value from 0-255 (0x00-0xFF) moves the gauge. Seems to work on a range of 38C to 120C
@@07trdpro6 Interesting! if can show a bit what behind it would be great!
Can you tell me the point to power it up
If you own a Routan/Chrysler gauge cluster, Pin 1 is actually 12V, and pins 8/10 are actually ground.
Some dialogue explaining what’s going on would be helpful… Jeez!
Hi, what tool did you use to send CAN messages?
Mainly an arduino based microcontroller with a CAN transceiver. Easy and cheap to setup with a lot of ability to read, filter, and send data.