ET DC Blue Advanced flashing "P" error fix

In this episode, we go through Fixing the P error on a DC Blue Advanced motor
Channel sponsors:-
Rsec Security Equipment Center
www.rsec.co.za
/ rsecequipmentcentre
/ rsecsecurity
Coast - Anno Domini Beats
Link to Products
rsec.co.za/product/dc-blue-ad...
00:00 Episode Intro
00:08 Intro
00:19 flashing P fix
01:00 Outro
Please comment, like, share, and subscribe to the channel
Follow me on Instagram:- @Nicks_nd_Tricks
Follow me on Facebook:- / nicksandtricks

[@2b.eating]

Thanks a lot!!

[@nicksandtrickssa]

You're welcome!

[@isaacmokoena402]

Hi Sir I have error P.Aftet resetting or programming instead of going to exit at the end it goes back to P and does not longer accepts remote after wards.I don't know what to do now

[@nicksandtrickssa]

Thank you for the comment, after it does the limit setup it will go back to flashing P, then you press exit 2x.
It will then go to standby mode and that is when you test it with the remote.
Where are you getting stuck?

[@JacobMhlambi-lt4lh]

Hi sir. I have error code E1 displayed on my garage motor when I try to open the garage.

[@nicksandtrickssa]

Thank you for the comment Jacob, please take it to the nearest re-seller to have it sent to NICE SA for repair, it's a PCB issue that has to be fixed, or purchase a new board

[@azizarichards1002]

Hello, I just adjusted my door because the gap was alittle to big on the floor... But now I get the P error when trying to open with the remote button... I then tried to reprogram the remote, I go to r and then b, when I press on my remote it give a number 2 and not number 1 which ma leans successful, can you let me know why that is please?

[@nicksandtrickssa]

Thank you for the comment, you can only adjust the door by doing the completed limit setup, it will flash P until you complete the limit set and the remotes will also only work once the motor confirms limit setup completed

[@azizarichards1002]

Thank you so much... It is working now after your comment... Much appreciated

[@nicksandtrickssa]

@@azizarichards1002 no problem, a like and sub to the Chanel would be greatly appreciated

[@ByronLat]

Hey Man do you know how to stop the beeping when the power goes off?

[@nicksandtrickssa]

Thank you for the comment Byron, unfortunately there is only 1way, sperglue in the speaker

[@ByronLat]

Thanks for the reply, yeah been looking everywhere to try figure out how to do it, would disconnecting the battery help? @@nicksandtrickssa

[@nicksandtrickssa]

Like I said, only 1 way

[@akshaynarshi827]

After I set the limits, Im getting a flashing 2 and 3?

[@nicksandtrickssa]

Thank you for the comment, flashing 2 and 3 is not something I have come across, u certain that's what it's doing, it's not a E and a number maybe?

[@akshaynarshi827]

@nicksandtricks1849 Apologies it displays E2 when trying to sent the limit.

[@nicksandtrickssa]

I believe E2 is an obstruction during the setup process, clear the obstruction to continue... Have a look at the door for physical issues