Did you use an alignment bar to check for housing straightness? And where did you get that pneumatic press to press out the old tube from the center section?
I did not use an alignment bar, I’m guess it’s a case by case basis, but it was straight and has many miles on it with no issues. I actually borrowed the jack and cylinder, but they are pretty common and not to expensive.
Good looking cj in the back ground
Thanks, picked that up last year
About time I found a Rubicon bent front axle re-tube video without some dude yapping. You are really hard on T-shirts.
Thanks, generally that's a $2500 axle assembly, repaired for less than $100
Did you use an alignment bar to check for housing straightness? And where did you get that pneumatic press to press out the old tube from the center section?
I did not use an alignment bar, I’m guess it’s a case by case basis, but it was straight and has many miles on it with no issues. I actually borrowed the jack and cylinder, but they are pretty common and not to expensive.
Only in Michigan 😂
I heard talking…
Prolly cussing at myself under my breath!