Brushless Micro Water Pump (diy)
Вставка
- Опубліковано 6 сер 2018
- 🙂 subscribe here: bit.ly/2Gwh9PI 🙂
INSTAGRAM: / off_grid_crafts
FACEBOOK: / offgrid-crafts-3995149...
**Building a micro dc brushless pump from a laptops fan. . it is very good for for a desktop fountain it works at 5v 0.4A ...stl files :
s000.tinyupload.com/?file_id=7...
thingiverse files: bit.ly/2SedTK8 **
other diy videos (lists):
water pumps: bit.ly/2U2S55G
photography: bit.ly/2GzlCko
electronics: bit.ly/2BIQWt5
locks: bit.ly/2Nc50zO
tools: bit.ly/2Gwis14
Why it's not for aquriam
Because some meterials are toxic.. if you are sure about the meterials you use maybe you can use it at aquarium
@@OffGridCrafts thanks a lot .
WoW the output is very meaty
WOW! Very nice!
Fantastic. I thought the same thing. I needed a weak filter for my Betta aquarium. I can use this as a filter engine. Of course, I need to change some of the materials you use and find another solution for waterproofing. Thanks for sharing the STL file.
Oww. link is dead. can you renew?
@@BoraYumusak yes my friend I will reupload it... wait to go to my computer
Thank you very much
done! the link is working now!
Красава. Только не понял, рыжая часть конструкции (корпус-крыльчатка) от чего?
Krasava. Just do not understand, red part of the design (body-impeller) from what?
Cool
Excelente vídeo
Tengo una pregunta
¿Que materiales usaste en el desarrollo del vídeo ?
cool, like and one more inscribed.
One question, I saw that you used another shaft instead of the original bearings, where did you get that shaft? can I make with the original fan bearings?
hello!!! thanks a lot!!
i found this shaft from an other fan without bearing... you can use bearings only if use the pump for oil (liquid cooling)
Nice
Its only diy if you have epoxy, a 3d printer, and a soldering iron
very nice music, what is it exactly?, i would like to obtain it for myself.
What is the song name
Why not for aquarium
Have you calculated how many liters this pump pumps per hour?
no.... i havent calculate it yet :(
What song is this?
Sorry man I don't remember... it was free from UA-cam's song list... if I find it I will reply!!
I tried to download the instructions for this but couldn’t open the rar file on my phone, even the four apps I downliaded to to this didn’t help
Hello my friend! At the zip file are .stl files not instructions.. you can open them with the tinkercad.com from pc
electronic crafts wow that was fast! I’ll try it on the pc then... but right now as I’m half way through opening up my pc fan (but not the same one from my pc!) I’m going to stick with it and hopefully I’ll get there... but where did you find the orange poi housing? I was a just going to make something similar with thermoplastic and hope for the best
@@nicola3540 I print it with 3d printer.. the material is pla
you should wear some gloves, sautering with that huge needle with bare hands is kinda dangerous
Cool