I’m in the process of getting all the bugs worked out of my trailer ABS system. Started off finding the bulb on the corner of the trailer was bad. Replaced that, then it would come on only when the brakes were applied. Replaced a bad relay on the truck which fixed that. The module is putting out 5vdc to all 4 sensor ports, & all sensors ohm out at about 12k ohms. My problem is that the ABS light doesn’t flash during the self check when the ignition is turned on. How do I tell wether the module is sending the signal to the light during the self check?
Hello, do you know how to disable Lane Departure/Collision Avoidance within this software? We see the setting but is greyed out and cannot be selected.
I used the Wabco toolbox to diagnose a freightliner m2 106 with an Cummins ISL 8.9. The ABS light is on but the wabco toolbox could not read any faults. What does that mean? Any help. thanks
I'm not really sure but, a liftable axle is programmed during the ABS programming?
I’m in the process of getting all the bugs worked out of my trailer ABS system. Started off finding the bulb on the corner of the trailer was bad. Replaced that, then it would come on only when the brakes were applied. Replaced a bad relay on the truck which fixed that. The module is putting out 5vdc to all 4 sensor ports, & all sensors ohm out at about 12k ohms. My problem is that the ABS light doesn’t flash during the self check when the ignition is turned on. How do I tell wether the module is sending the signal to the light during the self check?
Me too.
Hello, do you know how to disable Lane Departure/Collision Avoidance within this software? We see the setting but is greyed out and cannot be selected.
How do you find wiring diagram for this? Do Wabco website give you guys pin out diagram? I can’t find nothing.
I used the Wabco toolbox to diagnose a freightliner m2 106 with an Cummins ISL 8.9. The ABS light is on but the wabco toolbox could not read any faults. What does that mean? Any help. thanks
Fuse is probably blown
Can you use inline 6 to connect it to the truck?
Yes
I’m trying to connect it with inline 6 but no luck.
Then it must not be linked right to your computer
Información del escáner
Hello, I have wabco diagnostic interface 2, I just need the installation disk. can you sell me?
Sorry I do not sell any of the software I use
I have a 2008 freigtliner columbia with abs ligth on sid 013 it days retard relay open circuit ground. Please help
Sar ham per English nahin aati hai hamen Hindi mein samjhaie aap aapko