DIY - How we changed the oil on our Tohatsu 8 HP outboard which we use on our North Atlantic RIB RIB

Поділитися
Вставка
  • Опубліковано 14 січ 2025

КОМЕНТАРІ • 8

  • @leslienott1358
    @leslienott1358 Рік тому

    Did this modle have a oil filter

  • @Dewsdale
    @Dewsdale Рік тому

    Hi, very informative forna beginner like me. One question, did you use marine oil

    • @CruisingCalypso
      @CruisingCalypso  Рік тому

      Hi, Thanks for your comment. The oil is not specific to marine use just use the recommended weight and viscosity.

  • @mostlyguesses8385
    @mostlyguesses8385 2 роки тому

    Does 8hp tohatsu have oil filter, like 9.9?...

  • @Norman1965arg
    @Norman1965arg 2 роки тому

    How hard is to lift this engine? I'm planning to buy this engine to used in a 13ft inflatable boat.

    • @CruisingCalypso
      @CruisingCalypso  2 роки тому

      Great question! The motor weighs about 83 lbs, w/o electric start. Its a little awkward to move around but not bad. I can tell you that this motor on a 13 foot inflatable will be underpowered. The engine can plane my 10 foot rib w/two people but not with three. We are talking smaller people too. A 13 for boat needs a 15 at least or even a 25 if you want to plane. For comparison, think about a Boston Whaler 13 sport which often has a 40.

    • @Norman1965arg
      @Norman1965arg 2 роки тому +1

      @@CruisingCalypso thank you for the replied, i would be going camping and bring the boat to go fishing or cruising, not looking to go fast, also i want to make sure I can put it in the boat with no too much effort. I'm planning to inflate the boat at the destination and deflated once done, so i would be putting and taken the motor often, so that's why I'm thinking on something small like 8hp. Thanks again for your information.

    • @jamesa6272
      @jamesa6272 Рік тому

      I bought one. Must have put it on and off my row boat 5 or 6 times. Yesterday it fell into the water :(. It’s heavy and awkward. I have to replace all the oil and clean the carb out now. I’m hoping I can get it to start again after it being drowned.