Відео

Hi! Great video! I tried to find the excel in your web page but could not find it. Can you please send it to me? Best regards Magnus

Although you sound like Ben Stein when doing your over dubs, the comparisons were awesome!!

Don't need 12 months each of dock/mooring AND winter storage, do you? And if you're going to TOW it, do you need either? And haul/launch fees for a trailered boat?

I was expecting to see a rubber raft or kayak😊

It’s what I’m looking for,unfortunately JFB has things all messed up right now I’ll wait till next year but I’m looking now

this does not boost hp. Adding more fuel will just make the mixture rich so it might have a bit more torque but it will loose peak hp. To get more hp you need to add more fuel and air.

Where can I order this fixture

No way. Projecting. Bayliner or Meridian sport trawler/cruiser with diesels smashes these boats in every category at this price point. Edit: Good effort though, good effort.

Great Channel I enjoy all the content! I think I remember your boat one night in Cuttyhunk, we had a crazy storm come through. Hope your swim platform was okay. I’ll never forget that lighting and rain.

Very nice clean engines!

I have just bought a display 8hp Parsun motor. I understand it is a Mercury/Tohatsu clone. I plan on doing this exact same conversion, using an inexpensive generic 9.8hp carb. Can you please elaborate on what was misaligned so that the choke was jammed?

Do you have any photos of the underwater light's? Curious if they are factory or if they installed new ones

The performance shown is I believe for v drives . What improvement does the stern drive make ?

Climate change , buy the pilothouse cruiser with h.v.a.c. . and solar panels up there on the roof . You'll be glad you did .

@1:08 Please refrain from introducing additional noise after muting the recording due to wind interference next time. It can be quite bothersome.

I guess you also need the exhaust port round part.

Did they make older boots built stronger and better? Like how cars are now. New ones suck!

That’s because the boating market is too high

this is 2 years old how could this help me buy boat now BS

We’re looking for a yacht used for under $100,000 live board with a sliding rear patio style window entrance. The more like a condo it is the better. Two bedroom two bathroom. Can you recommend some models in that price range?

We’re looking for a yacht used for under $100,000 live board with a sliding rear patio style window entrance. The more like a condo it is the better. Two bedroom two bathroom. Can you recommend some models in that price range?

What an absolute pig. At 8.5 knots, consumption is 3.78 litres per mile. Ridiculous.

There are no " State Rooms" on this boat . There is a forward berth, barely a cabin.

If it's got a motor, a propeller, or a VA whinah,,you're gonna have problems with it.

italy limit boat , stupid frances

This video is so bad, it is almost comical. 😂

1:32. That didn’t age well.

Thanks for this. It's the first time that I've seen the motor being held instead of mounted to a frame while it was run. I think you have just saved me a lot of time and money.

Nice boat. I think I would prefer that over xxxxtug brands

Love to have that exel sheet

"Pass me the wrench...no, not that wrench" As a female owner of a vessel equipped with a CAT3126, I can appreciate that exchange! Learning a lot from your videos. Thanks!

i think you used wrong bleeder .should be the one above the filter been the highest point . NEVER use a wrench

How much?

If your in Australia not much. Everything is so overpriced here

"I Did. Thanks".

My 1967 27ft fibreglass/Hemp composite canoe, with cracked hull and broken seat, has better features than this rust bucket! 😡 Like, when the weather starts getting rough, and my tiny ship gets tossed, if it wasn’t for the courage of the fearless crew, (me) the Minnow would be lost! The Minnow would be lost!

9.9 is completely different bigger block more weight. 8-9.8 are proven motors for tohatsu dont break if it isnt broke.

I'll take it.

This is a great video. Thank you for this information into my early retirement for my Great Loop adventure and travel and life out my life on the water.

Hi, very informative forna beginner like me. One question, did you use marine oil

Thanks for the tour. A lot to like in this boat. I think view forward from the aft helm station would be adequate, but it's hard to know until you try it out. A real benefit would be docking -- the helmsman can see both transom corners when docking stern-to. And as you said, the helmsman is able to converse easily with guests sitting forward of the helm. I see so many Hinckley picnics boats running by my place with a lonely helmsman in the cabin and all the other passengers having fun in the cockpit aft -- very unsatisfactory. I think the covered area between the salon and aft cockpit in the Riviera would be delightful -- shaded but open air, very comfortable. The three cabin layout is fine, but I wonder if there is a two-cabin layout with a grand midship cabin available? That would be my choice. The only drawback to the Riviera is the need for isinglass for protection on the upper deck -- that stuff is horrible to look through.

that background noise 🤯

😥 "PromoSM"

Curious, why wouldn't you consider the Carver for open ocean? Is it stability related, motor related? Or just quality in general that it cannot handle that type of usage? Just wondering.

Dude did you voice Chris from family guy Lol

Given it's 2023, just wondering if getting a sea ray 340 as far back as say 2006-2007 is hazardous? Hazardous meaning is it too old and I should budget for more things to fix? Any and all comments welcomed by those who have gone through it. Thanks in advance.

Sorry just found this video. I have 2000 310 dancer. Looking at diesels on 38 foot fly. Which for you is easier to dock? Calypso I or II

What's the dry wt/towing wt for this boat?

I have one of those 3.5 hp champion single cylinder engines still. Runs great. It was my first outboard 1948 model.even have the original manual/ parts list pamphlet. 1 1000 merc "stacker" on a 15 in mid. 2 merc 700, '55 mark 25, a clone mark 40 H useing a 350 case" 2 porter" 2 port covers, all H insides ports moved up .060 " D, H specks. Whit lower coming and recoil housing top chrome band. KA carbs., C 30 h Quinncy filler block 40 h Reed blocks Tunner Dyke pistons h flywheel red Mag. 44 mod.

outstanding video! loved the finance bit as well