Such a great video, simple & straight to the point.. I want to thank you for the knowledge you share, however im prefer to use a rubber type hammer to knock the waterpump. That hammer you're using trigger my anxiety to the red line ... 😂
Good info. Mine wasn't so easy coming out but if you have a swan neck tire iron an slide it between the triangle pully mount and the pump housing you can get it rocking from both sides and it pops right out. Also I didn't remove the mount but had enough room for quarter inch drive ratchet. Thanks
Removing the mount give u all the space in the world once you do that... yes the water pump seal does get stuck so you gotta work it until it pop loose
Yea man very good job and your explication is very clear appreciate your special talents show thanks lot , I have a big problem with my Ford Focus year 2010 so engine mal function am check my radiator and also my temperature switch, now will check my water pump so I don’t understand where does that problem come my brother can you help me to have and ideas 💡
@rrednop3301 since u don't know .. once your finish fill the system up with coolant..leave the radiator cap off and let the car run and get hot...about 20 to 30 mins it should purge the air out of the inside of the car so it dont over heat due to trap air
My one is leaking at the other end of the engine, back side or the right side when you stand in front of car. It may be just a hose? Thanks awesome video by the way. I wish mine was leaking from where the water pump is positioned then I would know that it is indeed the water pump :)
Did you double gasket it? Did you clean the area b4 installing the new water pump? Is the bolts tight? Those will make it Leake again...unless your block is crack .....can you get it pressure test and see where it's actually leaking from?
Mostlikely it's the water pump. But do this to check..fill up the system threw the coolant bottle. Put the cap back on and run the car until it's hot and thermostat open and fans kick on.. look at the hoses at the coolant bottle see if it leaks if not look for drips on the floor ...seem like it's a slow leak you got but if your seeing residue on the side of the engine it's about 99.9% it's the water pump
@@platnumvi5057 its been a problem for a year now i couldnt find the leak so i thought it was heater core but now i see all rhat coolant… my guess is also that its the waterpump but id hate to cut into it and see that its not leaking yanno
@@MileytheJeepV2 yes if it's a small leak it won't really show unless u pressure test it and force it 2 leak..and if your seeing the residu on the side replace the water pump that the only thing on that side that had coolant beside the coolant bottle and if it was the coolant. Bottle or hose it would of been obvious with that leak....it's very easy to replace the water pump.. you can do it..
@@MileytheJeepV2 those water pumps are very common for their leak ..I'm doing a ford transit right now as we text with the same engine in it..water pump is no good
Stop being a fool ..do you know the torque spec ? Guess not...it's not even a full turn with a ratchet...now we know you don't know anything.. been doing this 4 years go learn something b4 being negative
Yes the oring is what make it stuck.. tap on it side by side with a small hammer and it will work it way out slow6 as you see a crack separation spray some wd 40 or dome sor in-between 2 help loosen it up
@Me7o2x it will budge just keep on tapping it out and pulling on it..they can be very stubborn to come out..if u can get a pry bar or so.ething small e uff 2 get in their and pry on it also thT will help but you got to get it from side to side
Nice instructions brother. You always make it look so easy.
I watched so many Videos with so many views but this was the best one to watch.I did the job all off this video.Thanks!
No problem..those other videos they did them in a complicated way..that y I made this 1
Fantastic Camera Angles and Clear Instructions, thanks man!!!
Such a great video, simple & straight to the point.. I want to thank you for the knowledge you share, however im prefer to use a rubber type hammer to knock the waterpump. That hammer you're using trigger my anxiety to the red line ... 😂
I hear you but you would be their for a week with a rubber hammer.. the seal seize it in and u actually have 2 beat it off with more force in a
You explained all Very sample ways.thanks brother
Any time
Best video on this subject
Good job. Very comprehensive
Good info. Mine wasn't so easy coming out but if you have a swan neck tire iron an slide it between the triangle pully mount and the pump housing you can get it rocking from both sides and it pops right out. Also I didn't remove the mount but had enough room for quarter inch drive ratchet. Thanks
Removing the mount give u all the space in the world once you do that... yes the water pump seal does get stuck so you gotta work it until it pop loose
Extremely helpful video thank you sir!!!!
Your welcome anytime
Badass job thanks for the help
No problem
Good video a lot help thsnks
Thank you sir! Very helpful!
Any time
Well done video. Thank you !
Any time
Yea man very good job and your explication is very clear appreciate your special talents show thanks lot , I have a big problem with my Ford Focus year 2010 so engine mal function am check my radiator and also my temperature switch, now will check my water pump so I don’t understand where does that problem come my brother can you help me to have and ideas 💡
What is it actually doing ? Over heating?
Excelente trabajo
Nice video great work hope we always communicate big like keep it up 🌹👍
Great brother
Great info! You definitely madeit look easier than other videos.
Thanks
Great video. Could you explain what you mean by "bleed the air out of the system".
@rrednop3301 since u don't know .. once your finish fill the system up with coolant..leave the radiator cap off and let the car run and get hot...about 20 to 30 mins it should purge the air out of the inside of the car so it dont over heat due to trap air
My one is leaking at the other end of the engine, back side or the right side when you stand in front of car. It may be just a hose? Thanks awesome video by the way. I wish mine was leaking from where the water pump is positioned then I would know that it is indeed the water pump :)
Bravo 👍🙏
Excelent!!!
Gracias
Did you remove the other motor mount or just that side that the pump is on?
Remove the motor mount just the side the pump is on And jack up the engine
am I tripping or is this video a mirror image? the belt an front cover aresuppose to be on the right side of the bay not the left!
It's. Mirror didn't realize it but shouldn't make a diffrence ..same steps to get it done
Love thank so much if I can a donation my in Detroit
Your welcome 🙏 🤗
My cashapp Cyber172000@gmail.com
Replaced water pump a week ago it started leaking again 9:24
Did you double gasket it? Did you clean the area b4 installing the new water pump? Is the bolts tight? Those will make it Leake again...unless your block is crack .....can you get it pressure test and see where it's actually leaking from?
How much you charge to do this replacement?
$200
It's cheaper than any shop price
I think my water pump is leaking but idk how i can tell… i cant see the water pump just that side of the motors covered in coolant
Mostlikely it's the water pump. But do this to check..fill up the system threw the coolant bottle. Put the cap back on and run the car until it's hot and thermostat open and fans kick on.. look at the hoses at the coolant bottle see if it leaks if not look for drips on the floor ...seem like it's a slow leak you got but if your seeing residue on the side of the engine it's about 99.9% it's the water pump
@@platnumvi5057 its been a problem for a year now i couldnt find the leak so i thought it was heater core but now i see all rhat coolant… my guess is also that its the waterpump but id hate to cut into it and see that its not leaking yanno
@@MileytheJeepV2 yes if it's a small leak it won't really show unless u pressure test it and force it 2 leak..and if your seeing the residu on the side replace the water pump that the only thing on that side that had coolant beside the coolant bottle and if it was the coolant. Bottle or hose it would of been obvious with that leak....it's very easy to replace the water pump.. you can do it..
@@MileytheJeepV2 those water pumps are very common for their leak ..I'm doing a ford transit right now as we text with the same engine in it..water pump is no good
@@platnumvi5057 its weird how i couldnt spot the leak for about a year but im just gonna go ahead and change it maybe itll fix my problem maybe not
He didn't even torque them, he'd never work on my car!
Stop being a fool ..do you know the torque spec ? Guess not...it's not even a full turn with a ratchet...now we know you don't know anything.. been doing this 4 years go learn something b4 being negative
How many time u take your car 2 a shop and they torque everything? Hmm 😒
@@platnumvi5057 15 ft pds numnuts get a life ,fool
@@platnumvi5057 only fools pretending to be a mechanic, mainly you!
Mines is stuck the whole engine moved that's how hard I was pulling
And its still stuck
Yes the oring is what make it stuck.. tap on it side by side with a small hammer and it will work it way out slow6 as you see a crack separation spray some wd 40 or dome sor in-between 2 help loosen it up
@@platnumvi5057 already did all of that and it's still super stuck
@Me7o2x it will budge just keep on tapping it out and pulling on it..they can be very stubborn to come out..if u can get a pry bar or so.ething small e uff 2 get in their and pry on it also thT will help but you got to get it from side to side