I do my filter from back of the tire. The last time I had the filter on an oil drip tray balanced nicely???? Ya it fell. Oil uummm everywhere!!!!!! The wind most times seems to be blowing when dropping the oil. I do partially fill the filter as it reduces the fill time and the gauges warning just starts then goes out. If one has to worry about clean new oil. Oh well?? Naaa mine drips all day while I grease and do other things. Anytime after 3:30 is good for filling. I use a filler with a ?? cap on it with ?? 20" or some length like that with a 500 lb sting to the cross supports to keep it in place. They are stored in a double plastic bag in a Rubber Maid for oil stuffs. I take the wheel well inside fender ????? off and stand on the tire grabbing the hood rubber bracket for on and off. They built my factory harness too SHORT!!!!!!!!!! So I got another WIF sender and lengthened them about 6 inch so I can almost get my shoulders into reach!!!!!!!!!! With the help of two long needle nose. Stupid by design! Did you have 6th Gear activated?
I have figured out how to reset the fuel filter light :) -Turn key ON, engine OFF -Must wait 5 seconds!!!! Then hold both brake and gas pedal down for 10-15 seconds -Voila! light out
I followed the instructions outlined in the video and my gmc 5500 is now a Mazda b2000. How many pocket screwdrivers will it take to turn it back? Also This is your best video yet dude. Slick editing and nice camera work. Keep up the good work!
Yes. Yes, that happened. In my Air Cat repair video, someone also remarked that I used a claw hammer with a punch. DO NOT FOLLOW MY EXAMPLE!! I'M A BAD INFLUENCE!!!
Yes I did last fall, sometime. It was easy to do. I think I, there was the oil drain so used a clear hose lowered that level . I did lift the front axle as that allowed me to turn the wheel pump out the old oil. opened to screw top and pulled it after I had replaced the old oil? I forgot how many Liters I used, wasn't too worried about the extra?? as listed amount. Then put the hoses back on.
Try this. Got to wait the 5 seconds. -Turn key ON, engine OFF -Must wait 5 seconds!!!! Then hold both brake and gas pedal down for 10-15 seconds -Voila! light out
You contaminated your fuel, when you added the old fuel from the fuel filter, into the fuel can. Never cross contaminate with filter fuel. Especially on the newer models, they don't like dirty fuel.
Naaaa my fuel was so clean from the two Donaldson filters didn't worry about that. ??? 55 1313/ 1000??? forgot. I put the one Cat 74? on it so good for a long time now.
I do my filter from back of the tire. The last time I had the filter on an oil drip tray balanced nicely???? Ya it fell. Oil uummm everywhere!!!!!! The wind most times seems to be blowing when dropping the oil. I do partially fill the filter as it reduces the fill time and the gauges warning just starts then goes out. If one has to worry about clean new oil. Oh well??
Naaa mine drips all day while I grease and do other things. Anytime after 3:30 is good for filling.
I use a filler with a ?? cap on it with ?? 20" or some length like that with a 500 lb sting to the cross supports to keep it in place. They are stored in a double plastic bag in a Rubber Maid for oil stuffs.
I take the wheel well inside fender ????? off and stand on the tire grabbing the hood rubber bracket for on and off.
They built my factory harness too SHORT!!!!!!!!!! So I got another WIF sender and lengthened them about 6 inch so I can almost get my shoulders into reach!!!!!!!!!! With the help of two long needle nose. Stupid by design!
Did you have 6th Gear activated?
I have figured out how to reset the fuel filter light :)
-Turn key ON, engine OFF
-Must wait 5 seconds!!!! Then hold both brake and gas pedal down for 10-15 seconds
-Voila! light out
helpful vid
Good info thank you.
I have a 2000 GMC 5500 topkick with a 7.4 motor which side of the motor is the O2 sensor bank 2 sensor one
Good job
I followed the instructions outlined in the video and my gmc 5500 is now a Mazda b2000. How many pocket screwdrivers will it take to turn it back?
Also This is your best video yet dude. Slick editing and nice camera work. Keep up the good work!
Geez, bud, this sounds more like a riddle than a problem! I'll give you two more screwdrivers on Monday for your troubles. And some candy, of course.
@Garret Seesing Depends on whether it's a Coyle Tools or Snap On Pocket Screwdriver. You'll pay twice as much for the Snap On ones for sure though.
So let me get this straight. You're a tool guy but you used Channelocks on the w.i.f. sensor instead of the actual tool? For shame Lindsay.
Yes. Yes, that happened. In my Air Cat repair video, someone also remarked that I used a claw hammer with a punch. DO NOT FOLLOW MY EXAMPLE!! I'M A BAD INFLUENCE!!!
Have you ever changed the power steernig filter?I have a C-4500 and want to change it.
Yes I did last fall, sometime. It was easy to do. I think I, there was the oil drain so used a clear hose lowered that level . I did lift the front axle as that allowed me to turn the wheel pump out the old oil. opened to screw top and pulled it after I had replaced the old oil?
I forgot how many Liters I used, wasn't too worried about the extra?? as listed amount. Then put the hoses back on.
My 2007 Gmc 5500 duramax fuel filter light wont go off either. Even after I depress the brake and gas for 10 seconds. So annoying
Try this. Got to wait the 5 seconds.
-Turn key ON, engine OFF
-Must wait 5 seconds!!!! Then hold both brake and gas pedal down for 10-15 seconds
-Voila! light out
@@JakeBrake7 you're right it did work! I just tried it. It was because I wasn't waiting the 5 seconds after key on. Thanks a lot
How do you prime fuel pump
Loosen the vent screw on the pump and press the plunger until fuel spits out, then tighten the vent screw.
How many litter of oil ?
You contaminated your fuel, when you added the old fuel from the fuel filter, into the fuel can. Never cross contaminate with filter fuel. Especially on the newer models, they don't like dirty fuel.
Naaaa my fuel was so clean from the two Donaldson filters didn't worry about that. ??? 55 1313/ 1000??? forgot. I put the one Cat 74? on it so good for a long time now.