Blower motor dont work on Honda Pilot 2018 2019 2020 2021 Replace resistor or blower motor

Due to factors beyond the control of RB The Mechanic, it cannot guarantee against unauthorized modifications of this information. RB The Mechanic assumes no liability for property damages or injury incurred as a result of any of the information contained in this video. RB The Mechanic recommends to follow safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of RB The Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not RB The Mechanic.
RB The Mechanic. All rights reserved. Publication, reproduction or distribution of this or any video by any means whatsoever, including without limitation electronic transmission via internet or e-mail, or re-uploading existing videos & re-uploading such material on any website anywhere in the world, is strictly prohibited without the prior written consent of RB The Mechanic.
#hondapilotblowermotor #blowermotordontworkhondapilot #pilotblowermotor #hondapilotblowermotor #2019hondapilotblowermotor #hondaresistor #blowermotorresistor #2019pilotblowermotorresistor #2020hondapilotblowermotorresistor #2017hondapilotblowermotorresistor

[@gordonchan8807]

Thanks old pro. Looks easy when you do it.

[@RBTheMechanic]

It should be easy!!!

[@foysholuddin3375]

Very good thanks

[@RBTheMechanic]

Thank you too!

[@stacimcclendon3907]

Does not apply to 2019 EX model.

[@gringobandito639]

Is it the same for a 2020 CR-V???

[@RBTheMechanic]

Yup

[@servo5651]

RB I SCREWED UP. I did timing on Honda Pilot. Went to start truck . It started and I forgot to put crankshaft pulley bolt on. The pin flew out engine stop. I rest timing now I have misfiring in every cylinder and I check with camera the valve they all look ok and move in and out. Truck is misfiring and has shake. Check engine flash and truck drives has power still. Reason for timing poor circulation due to water pump failure. No fins completely destroyed

[@RBTheMechanic]

Ummm might have damaged the engine I would give it another attempt and check timing reset it and make sure no damage is where the pin is once u have confirmed timing is good no damages at crank key pin area and it’s not able to move around then i would see how the engine performances if it still got misfire u can check compression but mostlikely bad damaged valve

[@servo5651]

@@RBTheMechanic oh shit look like I’m pulling heads

[@servo5651]

Compression on cold start
Cylinder 1346 at 85 90 psi
Cylinder 2-5 0 psi
Misfire confirmed on all cylinders so I’ll start tearing down the engine today. Timing was accurate so I guess the pin flew out and timing went off bending valves 😢

[@RBTheMechanic]

@@servo5651 yes I think that’s what happned

[@servo5651]

@@RBTheMechanic
If I take the valve covers off will I be able to see if something bent from there? I did a visual with the camera through the spark plug walls and rotated the engine. I didn’t see nothing wrong and the valves were moving up and down with the piston. I’m thinking a spring broke somewhere because I heard a loud noise after the rest somewhere under the valve cover that I thought was a spring

[@fisherbrown903]

2018 already broken?

[@RBTheMechanic]

It’s show and tell video just a demonstration