Looks great guys, I'm about to pull the trigger on a set of "BC Racing BR Type Coilover Kit (Extreme Low)" with the stock wheels will I need to "roll" my fenders after installing?
How much lower front and rear did you go from stock? Did you stick with the out of box height? Would love more context on ride quality/handling etc with these Coilovers in your next video. The stance looks great with the RF7's. Nice work.
The overall vehicle height was lowered about an inch. Ride quality is smooth but obviously stiffer to prevent bottoming out. The stiffness increasing the handling significantly though!
Those body kits are cool! Ive installed the same bc br series, and hearing knocking sound when I go through bumpy roads. Did you had any noise issue after installing those bc coilovers?
it may be the pre load like I mentioned...if not done right....thats what will happen...usually it's already done, but when I got my BC's they were not done so I set it to 5MM
Looks great! Question - Where in the adjustability range is that car sitting? I can't run my daily that low - so can the BC's accommodate a bit higher ride height?
They are probably terrible on the track, but who cares...90% of the people buying them just need them for stance...people need to understand that coilover sets are meant for different things...these will probably heat up 1st or second lap from stress and be worthless...but for the daily street driver wanting to stance the car and look good with an occasional "run"...they are perfect. They are NOT for serious track use
Hey gorgeous job on the model 3!! I'm also going the same route with the 2 inch drop. Just a question though, will it rub with passengers in the car with these wheel specs?
The Eibach springs will be similar to factory. The BC coil overs will make the car feel more planted but be slightly stiffer. They offer tons of adjustment compared to just springs
Hi where are you located ? I had coilovers on my tesla model 3 couple weeks ago , I heard rattle noise on bumpy street , I couldn’t figure out why and what caused the rattle noise. Any advices would be appreciated. Thanks
We are located in Gilbert, Arizona. The rattle could be various things. It’s common for the wheel well liner to rattle after lowering a vehicle. I would recommend looking there first and go from there.
Unfortunately we do not do local installations. You can check out the coilovers here - www.vividracing.com/racing-series-coilovers-telsa-model-awd-20172020-p-153266664.html
Just ordered VR side skirts to go along with the widebody I’m building…. But laying all the carbon fiber takes forever… lol…. Wet sanding my life away…. But should be ready by spring/summer of next year… we will see🎉😊
Bigger tires can have some effects in some regards but depends on how large the tires are! We have a video on the channel for a Tundra where we compare how the bigger tires affects power compared to stock that you should check out!
The car stance looks great. I love the tasteful modifications to the exterior. A nice and clean look.
When I get my tesla....THIS is how I want it to look.....looks clean AF!!!!!!
🙏🏼 Glad you like it! Let us know when you do get one, we would be happy to hook you up with some parts
I got to save this, a Model 3 is in my future. Love what you've done!
Thank you! Subscribe for more content 🙌🏼🤘🏼
Thinking about ordering these right now, to get the suspension in video were camber arms necessary?
No but they can help if you’re wanting to get a little more stance
Awesome job looks amazing !
Thank you!!
Looking amazing
Thank you!
Please show me more... As a stock model 3 owner, this is straight up pornographic.
Subscribe for more content 🙌🏼 plenty more to come
awesome stance!! love the wheels!!
Hey, which spacers do you use on the front and the rear? How many mm?
hello, what lower spring is it ? and what mm? thanks
Thanks for this upload. Did you tint the roof? Thanks
It is tinted!
Gorgeous 🔥 I want telsa now gonna drop it definitely
how is the car suspension now?...any noise....still going well?
What are the wheel specs on these! Love the fitment
Check it out here! www.vividracing.com/brixton-rf7-wheel-set-5x1143-tesla-model-p-152682108.html
20" 5 x 114.3!
wow and wow!!! this is sickness!! Whats the ET for the wheel specs ?
Shoot email sales@vividracing.com
Looks great guys, I'm about to pull the trigger on a set of "BC Racing BR Type Coilover Kit (Extreme Low)" with the stock wheels will I need to "roll" my fenders after installing?
does the back scrap when you supercharge the car?
How much lower front and rear did you go from stock? Did you stick with the out of box height? Would love more context on ride quality/handling etc with these Coilovers in your next video. The stance looks great with the RF7's. Nice work.
The overall vehicle height was lowered about an inch. Ride quality is smooth but obviously stiffer to prevent bottoming out. The stiffness increasing the handling significantly though!
Software tuning ???? 0-60 times in the low 2 seconds, like a separate application you can go to like a plaid mode?
Unfortunately, we do not have software tuning for Tesla models.
We do have a pedal tuning box however www.vividracing.com/booster-pedals-c-7192.html?keywords=tesla+tune&manufacturers_id=2178
What size are wheel and tires
Those body kits are cool! Ive installed the same bc br series, and hearing knocking sound when I go through bumpy roads. Did you had any noise issue after installing those bc coilovers?
We did not, defiantly refasten everything down!
it may be
the pre load like I mentioned...if not done right....thats what will happen...usually it's already done, but when I got my BC's they were not done so I set it to 5MM
Looks dope af… sadly I can’t do this where I’m from.
We agree! It sucks you aren't able to do the same! :(
super clean !
We appreciate it, thanks for watching!
Looks great! Question - Where in the adjustability range is that car sitting? I can't run my daily that low - so can the BC's accommodate a bit higher ride height?
Yes it can…. Very much so actually
I'll never own a Tesla, but I do love what you've done with it!
Thank you 🙌🏼
@@vivid_racing Your welcome!
What did you use to tint the head lights ?
Might have been spray but we do sell the Lamin-X tint covers www.vividracing.com/index.php?keywords=lamin-x+tesla&page=2
@@vivid_racing was looking into spray but seems too much work lol
Any scraping in the ground?
Most of the time, no. It only scrapes over steep inclines.
Would prefer to see some quality redwood or mountain pass coilovers installed
what if we just called them Sequoia?
What did you end up lowering it by compared to stock? Did it need camber arms as well? - Looks amazing!
It was lowered about 2 inches compared to factory ride height. The only thing that was installed was the coilovers and wheels!
What kind of wheels are those, they seemed to pop out more flush with the car body.
nice but needs better wheels with decent offset
What wheels would you recommend?
BC Racing Coilovers? So when do we see what they can do for the 3 on the track as opposed to posing on the street
That will be a matter of tracks being open to the public and having events again due to the pandemic 👍🏼 will possibly be a future video
They are probably terrible on the track, but who cares...90% of the people buying them just need them for stance...people need to understand that coilover sets are meant for different things...these will probably heat up 1st or second lap from stress and be worthless...but for the daily street driver wanting to stance the car and look good with an occasional "run"...they are perfect. They are NOT for serious track use
Hey guys, are these the standard BC Racing BR coilovers or the Superlow/extreme shocks? Thanks in advance!
Hey! These are the exact ones we installed: www.vividracing.com/racing-series-coilovers-telsa-model-awd-20172020-p-153266664.html
Can you guys install this on my M3 Performance?? Please??
Unfortunately we do not do local installations, sorry
Vivid Racing Would you have a recommendation for a shop to install in the Phoenix/Scottsdale area??
no rwd version of these?
Tesla discontinued their RWD version of the Model 3.
@@vivid_racing damn I guess we rwd owners get no love
Hey gorgeous job on the model 3!! I'm also going the same route with the 2 inch drop. Just a question though, will it rub with passengers in the car with these wheel specs?
Roll your fenders lmao
Staggered wheelset, or is it 20x9 all around?
we now run our square setup www.vividracing.com/forged-d03r-wheel-package-tesla-model-model-20x95-gunmetal-p-153792397.html
what rides better these coilovers or the eichbac springs?
The Eibach springs will be similar to factory. The BC coil overs will make the car feel more planted but be slightly stiffer. They offer tons of adjustment compared to just springs
Lifted model 3? Try to fit a 17in wheel, M/S rated tires... Tesla Rally Model 3
🤔🤔 you just might be on to something
@@vivid_racing 👀
Just out of curiosity, as I’m not too familiar with modding teslas do coils set off any warnings or error codes on them?
Zero issues
Is it to low to we're it can damage the battery??
Nope still driving that thing
I see the cloud plate. You guys based in AZ? Which part?
We are located in Gilbert, AZ!
Man which i would have known. I was over in buckeye but recently moved from AZ. Would have been great to link up
Spacers? If so, what size?
No spacers!
What rim size?
Those are 20". Check out our Tesla fitment here www.vividracing.com/index.php?keywords=vr+forged+tesla+model+3
Looks like the pre load is off…. Like you lowered the car using the preload adjustment instead of the shock body
Did you guys install cambers kits on both front and rear? If so, which brand? Thanks
We did not!
Does it being lowered affect the autopilot/cruise control features?
Not one bit! Autopilot and cruise control is still fully functional 🙌🏼
@@vivid_racing That's awesome to hear. I've got a 2020 Model 3 myself and was considering doing something similar!
We can get you hooked up! We sell everything on this vehicle 🙌🏼 shoot an email over to sales@vividracing. com
At the softest setting, are these coilovers the same or softer than stock? I want to lower mine but don't want a stiffer ride than stock
The softest is still a bit stiffer than stock but not as noticeable and still provides a great ride quality!
What window tint is that and what % are? Thanks
20% in the rear and 35% on the front windows
What brand are they?
DaMn imagine it with a huge wing and front splitter
Hi where are you located ? I had coilovers on my tesla model 3 couple weeks ago , I heard rattle noise on bumpy street , I couldn’t figure out why and what caused the rattle noise. Any advices would be appreciated. Thanks
We are located in Gilbert, Arizona. The rattle could be various things. It’s common for the wheel well liner to rattle after lowering a vehicle. I would recommend looking there first and go from there.
Got my Works from Vivid, whats the cost for this setup installed?
Unfortunately we do not do local installations. You can check out the coilovers here - www.vividracing.com/racing-series-coilovers-telsa-model-awd-20172020-p-153266664.html
Does this affect the warranty on the Tesla?
Anything installed incorrectly that leads to a breakdown can void the warranty.
Freaking awesome!!! 🤘🤠
Thanks for watching!
Just ordered VR side skirts to go along with the widebody I’m building…. But laying all the carbon fiber takes forever… lol…. Wet sanding my life away…. But should be ready by spring/summer of next year… we will see🎉😊
Right on!
what size tires are thay?
Falken Tires 285/30/20 rear and 245/35/20 front.
Amazing 👏
We appreciate it, thanks for watching!
25mm spacer needed in the front! Nice set up tho.
Good call!
Niiice Slick af.
Do these mods impact performance? Vehicles are tuned for the stock parts... wondering how different tire sizes impact mileage range.
Bigger tires can have some effects in some regards but depends on how large the tires are! We have a video on the channel for a Tundra where we compare how the bigger tires affects power compared to stock that you should check out!
stunning
Thanks for watching!
Bagssssss
Would be a good option as well, but we chose coilovers 🙌🏼
BAGS FOR LIFE! UAS Makes a great kit.
Nice lets mess tesla
Way better looking this way
Looks too tuner
now its just another dork car that takes an hour to go over speed bump lol
Car is daily driven with no issues
@@vivid_racing glad you can,, i would have it trashed in about 10 mins the way i drive lol