Installation SoundTraxx Tsunami2 with TCS K4: Athearn Genesis EMD F7
Вставка
- Опубліковано 26 сер 2024
- tonystrains.com/
We take a look at the basic components required for installing a SoundTraxx Tsunami2 PNP type decoder and TCS KA4 Keep Alive into an HO scale Athearn Genesis EMD F7.
Following are links: tonystrains.co...
tonystrains.co...
tonystrains.co...
As I just purchased one of these it would have been beneficial to see how to remove the shell.
Im modeling the SP, how would I be able to add the red emergency light, the top light, and the flashing mars light all those functions in one decoder?
Your videos are really very good, straight forward and no BS. Always look forward to your share of knowledge, thanks.
Soo...I assume you wired the KA4 into the connector on the board, do you sell the connectors/pigtails to do this? Great video, lets hear it run!!
Is there a source for the female connector that mates to the Soundtrax current keeper male receptacle? Or is there a direct solder method to install the TCS Keep Alive
nice install video thanks for sharing....
Nice video, but please tell us how the K4 Keep-Alive wires into the decoder. I'm new to keep-alive circuitry and this is what I desire to know. I understand a keep-alive gets soldered into the bridge rectifier points on the decoder. Where are these points? I don't see where you have accomplished this step in this video. Thank you.
Tsunami2 decoders have a 2 pin plug to connect a harness wired to the stay alive device from either SoundTraxx or TCS:
tonystrains.com/product/soundtraxx-810140-currentkeepertm
tonystrains.com/store/dcc-sound-and-power/dcc-stay-alive-capacitors?manufacturer=371
See page 20 where to plug in the harness:
soundtraxx.com/content/Reference/Manuals/Tsunami2/Installation-Guide.pdf