2020 STI Brake Pad Replacement
Вставка
- Опубліковано 26 жов 2020
- easy stuff
owner: @vmom98
************************
www.fdauto44.com
************************
The facebook page
/ fulldetailautomotive
Instagram page
@fulldetailautomotive
/ fulldetailautomotive
exclusive instagram hashtag
#fulldetailautomotive
----------------------------------------------------------------------------------------------------------
music provided by:
JUNKO OHASHI - I LOVE YOU SO
-----------------
KILO- r.munoz
Instagram: / rrodrigomunoz
Twitter: / roddrigomunoz
Soundcloud: / roddrigo-1
Bandcamp: roddrigo.bandcamp.com/music
Beatstars: www.beatstars.com/ninetyeight - Авто та транспорт
Just found you by this video. You've taken car install videos to a whole new level! 💯
Thank you very much. It means a lot
I’m to the point now where 10 seconds into the video I just press the like button automatically.
Great video as always!
Great video. Super entertaining. Keep it up!
I like the addition of City Pop lol
Thank you, I never had a car that had big brembos like this I was worried it would be a lot more difficult. Appreciate it.
Its wayyyy easier than regular calipers
@@FullDetailAutomotiveside note, what brake fluid should I use? I’ve got a 2021 sti would DOT 3 or DOT 4 work ?
@@tb6516 either is fine. They're basically the same. Just make sure you're using name brand fluid.
i see that bunta fujiwara sticker!
Love the video
Great video. What's the torque spec for front n rear caliper bolts?
The calipers never came off so I don't know.
caliper bolt is 88ft lb,I did 90 ft lb on them, the bolt located in the middle of the caliper is 23ft lb
Question: I noticed that there are some grooves in the rotor? Are the rotors able to be turning or is that even required?
You can turn drilled and slotted rotors but its not recommended. If you can find a place that will even do it then go for it but its best that they are just replaced. Its one of the downsides of "race" parts.
@@FullDetailAutomotive so for that sti just replacing the pads is good until next time you have to change your pads?
@@ZeNkIxFc so long as the rotors are within spec, replacing just the pads is fine. Rule of thumb is if there is a lip on the edge of the rotor then it needs to be replaced. There are actual measurements to make the determination but if you're at that stage then just replace them.
@@FullDetailAutomotive awesome! New sub for sure, great video 🤙🏼
What type of break bad are best for this type of vehicle?
Depends on the driver
What brand is best?
allways share for the betterment of man. what you measure out will be measured back out to you
Song name?
Literally in the video.... watch the video
also in the description
Video kinda sucks
Good