TRANE RTHD’s Had Trouble Restarting After Power Outage | EMS Override!
Вставка
- Опубліковано 11 кві 2024
- Got a work order stating chillers not starting up , had to troubleshoot where the night crew left off #chiller #hvac #airconditioning
- Навчання та стиль
Tom. glad you understand what you do very well. Getter done!😊
Thanks 👍
For your noise in the tower gearbox, many times the drive will set up harmonics in pumps and fans that cause noise. One B&G pump rep called it "cogging". Most drives will let you skip over frequency areas that cause issues. So just play with drive in manual control and record the troublesome frequency's and exclude the drive from operating in these areas. Good job figuring out what happened and following trail of the illusive "maintenance man/ service work creator". I used deal with a building that had the cooling basin was the lowest point in the system, one power blink and a large percentage of the tower water was on the ground and the tower pumps were trying to pump air. Enjoy you time at the service trade!
Excellent, Thanks for that tip, it seemed to be more noticeable in the mid 20HZ - 30HZ range . Makes sense 👍
good stuff brother, hopefully things have been going good!
All is good 👍
I appreciate your content man. We work on similar equipment and when I’m scheduled for a service call I use your videos as reference tysm
I’m glad it’s helpful, Thanks for sharing 👍
Good troubleshooting
👍 Thanks!
The shaft on that motor on tower 1 looked a bit wobbly. Thanks for the video bud
I think it’s the shaft key and anti-seize making it look that way, I was wobbling too up there! Thanks Eric !
Good work subcool
Thanks Nick 👍
Nice work Subcool.
Thanks Steven 👍
nice video!
Thanks for watching cc 👍
there is a simple solution of putting a reverse trap on the end of that line to keep it full of water and not overflowing your tower or draining your sump when the pump starts up
There may be a check valve sticking the more I thought about it. Thanks for the suggestion too 👍
0:16 are we inside the matrix
😎 💯 Real
Sounds like the gearbox is crapped out? Or a bearing in there going bad. Perhaps it has been low on oil before, and there is a missaligment of the gears?
Great Video. Thank you for sharing. Have a nice weekend. Why is cooling Tower have alot water like pool ?
The Basin collects the cooled condenser water being circulated through the condenser loop, the pump draws from the bottom of Basin 100% liquid to avoid air cavitation . Thanks for the question 👍
✅👍👍👍
Thanks for watching!
Great video. What do yo think of those ABB variable frequency drives? Reason i ask is because i work on a chiller at an ice rink as well as a big high school, and they both have those same drives, but they have been very problematic. More so the ones at the high school than the ice rink. The school chiller is a carrier unit and the cooling tower is a BAC Baltimore Air Coil brand. I have also worked on the Evapcos as well. What i like about the BAC cooling tower is the fan motors are right inside the tower, and use a belt and pully to turn the blade which i think is way better than that drive shaft system that evapco uses like the one here in this video. Now dont get me wrong, changing those bearings on the bac towers can be a pain especially if the bolts are rusty. I have did many. The ice rink chiller is made by Cimco Toromont, and uses R 717 Amoina for the refrigerent, and glycol for the secondary coolant that is chilled and pump through the tubing in the rink floor. These chillers can be a pain. Also they are not that good at removing the humidity like a standard ac unit will do. You have to have a stand alone dehumidification system with a chiller. The ice rink has a Munters brand dehumidifaction unit. Lots to these systems. Takes people with good knowledge and dedication to keep them maintained.
We mainly use ABB drives with good results with the correct motor info setup
Great job are you looking at R/R the gear box or the motor ?
If anything would be gearbox. Thanks
If you don’t mind what kind of watch are you wearing
Sure, apple watch 8 series 45mm with amband strap. Thanks for watching!
Apple Watch Series 8 [GPS 45mm]... www.amazon.com/dp/B0BDJDH2WR?ref=ppx_pop_mob_ap_share
There are T-shirts available with "I'm not to be truffled with"
"Michael says the phrase when he sets rules and people follow them blindly. He also says, "No matter how I look at this, I am in the wrong. And I have looked at this thing like 100 different ways, from my point of view, from their point of view, 98 others, and bottom line: I am in the wrong. I'm the bad guy"."
I would never Truffle my Boss 🤣 Thanks for the compliment 👊👍