UPDATE: Since the servos won't stand still (or start running in sync), I ditched the internal controllers and soldered an ESC per side to it. Fixed it very nicely!
Not how its done. How you chose to make it function in your mind. I do like how you set it up. But not the only way and others may or may not want to do this. Again, i like it. Its not bad, but others may want different set up.
Very good Rc 😄👍🥰
Nicely done :-)
How did you go about wiring your 4 drive servos? Did you use a “y” connector for each side?
I wired the two servos of each side in parallel. As far as I remember, I soldered it. You can use a Y-cable, too.
UPDATE: Since the servos won't stand still (or start running in sync), I ditched the internal controllers and soldered an ESC per side to it. Fixed it very nicely!
Frog Fish hi nice project. Before putting those esc how did you connect the battery? To receptor?
@@frogfish5612 would it be the same to use a big servo controller for each side and use only gearing on small ones?
maxi maldo I believe I connected the battery to both ESC, but removed the + cable on one of them, so the Receiver gets power only from one.
Not how its done. How you chose to make it function in your mind. I do like how you set it up. But not the only way and others may or may not want to do this. Again, i like it. Its not bad, but others may want different set up.