Whirlpool Dishwasher not spraying water and stop cleaning - How to fix it
Вставка
- Опубліковано 2 жов 2023
- My Dishwasher stop cleaning so I put my iphone inside to see what happening and realize that water flow inside is very weak and propeller spraying arms is not rotating. So I take off water recirculating pump and see that it completely clogged. After cleaning everything start working.
Check this video how I make it.
If you damaged your spray arm you can replace it with a new one.
Whirlpool W10448645 Dishwasher Spray Arm - amzn.to/3F5uYkl
This is some spare part of whirpool dishwasher if you realize that they don't work:
Dishwasher Circulation Pump - amzn.to/3LMrO8P
Always check you part part number with a replacement part that they compatible. - Навчання та стиль
Yours was the only video I could find with this model of Whirlpool. This was exactly the same symptoms and the same clogged motor as my mother’s dishwasher. It was actually way more time consuming just getting the dishwasher out because of a short, hard to reach water hose and equally frustrating hard-wired power cable. But once I finally got it out your clear instructions on removing and cleaning the motor were spot on! Saved me hundreds of dollars! Thank you, Mr. Stukov!
excellent vid. took mine apart and checked this out, but it was clean as could be. kept searching YT and found one where the guy used a toilet plunger to clean the line from inside the cabinet. tried that and between ensuring the pump was clean and purging the line within the cabinet, works like a charm. Thanks! New sub.
Thank you so much for this video!!!! I was seconds away from purchasing a new dishwasher when I found this tutorial. The circulation pump was dirty. My dishwasher is working beautifully now!!!!
Thank you so much, saved my dishwasher. Broken glass and lemonade seed in it! Now working as should again.
This 100% was our issue. Thank you Sir!!!
Dishwasher would fill and drain but there was no spraying at all. Took the unit out(had to disconnect hardwired electrical but it was easy) removed the gunk from that piece and it works!!!
Thanks!!🎉
Thank you sooo much for posting this! This was part of the problem with our dishwasher that needed fixed. Keep up the good work!
Thank you so much man, you saved me hundred(s) of dollars of reparation fees. There was a single strong fiber stuck in the pump motor
👍
This video just saved me hundreds of dollars! Bless you sir
Thank you! Had a piece of plastic stuck in there worked perfectly after removing!
Hi there, do you have a video on how to snap the sprayer arm apart without breaking it? Or can you explain to me how you got it apart?
Thanks for the video, my dishwasher is working like new!!!
Simple and excellent! Thank you!
100% Fixed our dishwasher.
Fixed! Hair around the motor. Used a little hook tool to clear it out. Hooked back up and cycle started! Yay
thanks for this. my motor was fairly clean, but had some glass causing the impeller to seize.
Nice and to the point! thank you sir!
Thank you! Had a piece of plastic lodged in mine.
Rock star. Very resourceful. My turn.
Had some gunk and chunks of plastic in my propeller. Thanks for the video..
Glad to help
Thank you for you video
thank you sir!
Thanks man
Mine had the same problem..yet it was fairly clean..but there is a screen under the impellar Hydro turbine which requires cleaning with a tooth brush and dish soap..the area in which the fellow in this vid is pulling out debris is the impellar housing remove the 4 screws and you can gain access..simply unwind(unscrew) the impellar from the threaded shaft to expose the screen below..it's ridiculous how such a small part blockage can cause a complete shut down of the machine- my model is WDT750SAHZ0..note to remove the pump you must tip the pumps square side post out of it's rubber insulation slot at the bottom of the machine..turning it clock wise..I had a tough time turning it so used WD40 on the contact rim..also remove the interior wash screen first and also the pump power clip..the smaller other pump is for the machine draining only..push 3 of the mode buttons 3 times each consecutively a total of nine to enter the machine reset and cycle..the machine will cycle through for errors..and reset.
How did you get the washer arm apart?
How do you "extract your dishwasher" so you can get to the motor ?
How did you open the propeller arms? They seem to be glued closed on mine (same model). And how did you close them after? They seem to be built to prevent people from opening and cleaning!
Hey I know it’s a late reply, but they are just click in, flat head screwdriver and should be able to let it open. Then click back together.
I think they are glued I opened mines and it won’t close now
Mine was clean as well but can't get it back on properly so it doesn't leak
How did you have light in there? I tried to 'wash' my GoPro, but it's completely dark in there and nothing can be seen
I just use my iPhone before filming I Turned on flashlight on it.
Here’s how:
1. Open the camera app and select video mode. Note: The flash does not work in pano or time-lapse modes.
2. Swipe up in the middle of the screen, away from the shutter button, and a hidden toolbar will slide up across the bottom bar, in place of the camera modes.
3. Tap the flash button (on the extreme left of the toolbar) and the flash modes will scroll out from the button. Tap “on.” The flash will turn on instantly, even when you aren’t recording, and will remain on until you switch camera modes or close the app.
U can also try flipping the door switch so the machine detects the door is closed and partially open it to see inside
Bingo!
Now you know not to put dishes that have debris into the dishwasher 👍
Food waste goes into the trash not in dishwasher !!
I can't get get the pump disconnected. Why the hell was yours so easy? 😂
Как ты засунул туда айфон?
Nothing was clogged looked clean inside did not help at all
Probably your inlet valve
Guess you need to actually DIAGNOSE IT YOURSELF. The guy does a helpful video and you give him crap for it
Mine was clean too but magnet was cracked when I pulled it out, the propeller didn’t spin freely
@@Max-zz3ttwhat do you mean it didn’t spin freely
Awesome video, I like the phone in dishwasher.